Installation Guide

Installation and Fabrication Guide
Page 2 of 4
Product
Wilsonart® RE-COVER™
October, 2014
Warning
WARNING! Removal of old paint by sanding, scraping or other
means may generate dust or fumes that contain lead. Exposure to
lead dust or fumes may cause brain damage or other adverse health
effects, especially in children or pregnant women. Wear an NIOSH-
approved respirator to control lead exposure. Clean up carefully
with a HEPA vacuum and a wet mop. Before you start, find out how
to protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD (in US) or contact your local
health authority.
Installation
Thank you from the Wilsonart Team for using Wilsonart® RE-
COVER™ Laminate. If you have any questions, please call us toll-
free at 800-433-3222.
If you are bonding over an existing substrate that is damaged, the
surface may require repair to prevent an uneven appearance of the
finished assembly. The Wilsonart technical services team recommends
these products for repairing damaged high pressure decorative laminate
or wood substrate: J-B Weld® WoodWeld, Elmer's® Carpenter's® Wood
Filler, and Bondo® All-Purpose Putty. Be sure to read and follow the
manufacturer's precautions and directions for use. Sand and clean all
repaired areas before applying the Wilsonart® RE-COVER laminate.
Approved substrates must be used. They should be clean and free of
residue. If bonding to an existing decorative surface, make sure it is
adequately cleaned and dried before bonding. Suitable cleaning products
include: Wilsonart® 110, Wilsonart® 121, Wilsonart® 130, Wilsonart®
131, Wilsonart® 131A, acetone, isopropyl alcohol, denatured alcohol, or
Windex® with ammonia. DO NOT use a cleaner that will leave an oily
residue. Allow proper dry time for all approved cleaners. Be sure to read
and follow the manufacturer’s precautions and directions for use. If
bonding to a painted, stained, or varnised wood or wood veneer, make
sure the surface is sanded smooth and uniform with #80 or #100 grit
sandpaper. Remove all dust with a damp cloth. Allow to dry.
To precut Wilsonart RE-COVER laminate prior to bonding, we
recommend using carbide tipped saw blades, router bits and laminate
slitters. Cutting blades and router bits should be kept sharp and clean.
Blades must cut into non-decorative side of laminate (adhesive side).
When cutting on a table saw, place laminate face down (adhesive side
up) to ensure a clean cut.