Installation Guide

Installation and Fabrication Guide
Page 4 of 4
Product
Wilsonart® RE-COVER™
October, 2014
Installation (cont.)
A radius may be accomplished by using 735 material only. Using 735
material will allow for a minimum radius of 7 inches.
Once bonded, you can begin machining the Wilsonart RE-COVER
assembly immediately. High tool speed and low feed speed are
recommended for best results. Prior to routing edges, a razor may be
used to score the adhesive side of the laminate to prevent the adhesive
layer from rolling up during the process. To avoid stress cracking, do not
use square-cut inside corners. All inside corners should have a minimum
of 1/8” radius. Drill oversized holes for screws or bolts. Screws or bolts
should be slightly countersunk into the face side of a laminate clad
substrate.