Instructions / Assembly

To avoid stress cracking, do not use square-cut inside corners. All inside corners should have a

minimum of 1/8” (3.175mm) radius and all edges should be routed smooth.

Drill oversized holes for screws or bolts. Screws or bolts should be slightly countersunk into the face

side of a laminate-clad substrate.

Take care to ensure an appropriate acclimation between the laminate and the substrate prior to

fabrication. The face and backing laminates and the substrate should be conditioned in the same

environment for 48 hours before fabrication.

Recommended conditioning temperature is about 75°F (24°C). Laminates should be conditioned at

45% to 55% relative humidity.

With postforming machinery, Wilsonart 362/367 and 372/377 will postform at a nominal sheet

temperature range of 325°F to 350°F (163°C to 176°C) in 20 ± 5 seconds.

Carbide-tipped saw and router blades should be used for cutting. High tool speed and low feed speed

are advisable. Cutting blades should be kept sharp. Use a hold-down to prevent any vibration.

5. Warranty

6. Maintenance

7. Technical Services

For samples, literature, questions or technical assistance, please contact our toll-free Hotline at (800)

433-3222, Monday through Friday, 8 am – 5 pm, CST.

Specification Form

Surface shall be Wilsonart Virtual Design Library Laminate, produced by Wilsonart LLC,

Temple, Texas 76503-6110

Type: Specify 362, 367, 372 or 377

Surface

Color Number: _____________ Color Name: ______________

Finish

Number: _____________ Name: ______________

Edge Trim

Color Number: _____________ Color Name: ______________

Adhesive

Name: _____________ Grade/Type: __________

Brand: Wilsonart® Adhesive

Wilsonart® VDL Laminate Technical Data

Revised: September 8, 2017