Use and Care Manual

6
Adjustments and Operation
Before use, inspect the vise for cracks, misalignment,
binding, or any other problems that may compromise
its safe use.
Handle adjustment
Refer to Figure 5.
The handle hub is spring-loaded, and allows the
handle to be repositioned without moving the jaws.
After securing the workpiece in the jaws, grasp handle
hub and pull out. Rotate handle hub to desired
position, then release.
Figure 5
To operate the hitch vise:
1. Turn screw handle counterclockwise to open
jaws. Do not try to force jaws apart farther than
the rated capacity/jaw opening.
2. Choose the straight jaws or pipe jaws. Insert
workpiece and turn handle clockwise to close
jaws.
3. Tighten enough that workpiece can no longer be
shifted within the jaws. Do not overtighten, as this
may damage workpiece and/or jaws.
Maintenance
Inspection: Before use, inspect vise for
misalignment, binding or cracked/damaged parts, or
any other condition that may affect safe operation.
Repair or replace a damaged vise.
Cleaning: After use, wipe external surfaces of the
vise with a clean rag. Apply a light coat of machine oil
to exposed metal areas.
Lubrication: The leadscrew is permanently lubricated
and enclosed, and should not require attention.
Lubricate other moving parts of the vise with machine
oil.
Jaw insert replacement: Use a 5mm hex key to
remove two screws on the jaw insert. Securely tighten
the new jaw insert to the vise using the same screws.
NOTE: If replacing jaw inserts, replace both as a set.
Replacement Parts
To order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8AM to 5PM CST.
Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly
and accurately.