Use and Care Manual

#28830, 3-inch Swivel Base Machinist Vise (model 300S)

Replacement parts

Item Part No. Description

1 2900000 Spindle Assembly Complete

2 2904000 Spindle Retainer (with 3 screws and #3)

3 --- Thrust Washer (not available separately)

4 2903080 Serrated Jaw Inserts with 4 screws

5 2903100 End Piece Assembly Complete, with 2 pins

6 2903110 Casing Nut with 2 pins

7 2904060 Lock Nut Assemblies

8 1010900 Inner Ring with Dowel Pin

9 1012010 Outer Ring only

10 2904370 Swivel Base Assembly Complete (includes #7,8,9)

To order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model

Number and Serial Number of your tool available when you call will allow us to serve you quickly and accurately. Some parts are shown for

reference only, and may not be available individually.

WILTON

427 New Sanford Road

LaVergne, Tennessee 37086 M-28830

Ph.: 800-274-6848 Edition 1 09/2018

Note: See reverse side for important safety instructions.

Specifications

Stock no.

28830

Model no. 300S

Jaw width 3 in. (76.2 mm)

Jaw opening 4-3/4 in. (121 mm)

Throat depth 2-5/8 in. (67 mm)

Net weight 30 lbs. (13.6 kg)

PAGE 1
#28830, 3-inch Swivel Base Machinist Vise (model 300S) Specifications Replacement parts 28830 Item Part No. Description Stock no. 1 2900000 Spindle Assembly Complete Model no. 300S 2 2904000 Spindle Retainer (with 3 screws and #3) Jaw width 3 in. (76.2 mm) 3 --- Thrust Washer (not available separately) Jaw opening 4-3/4 in. (121 mm) 4 2903080 Serrated Jaw Inserts with 4 screws Throat depth 2-5/8 in. (67 mm) 5 2903100 End Piece Assembly Complete, with 2 pins Net weight 30 lbs.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS • Misuse of vise can cause serious injury to eyes, hands, limbs, etc. • To ensure safety, vise must be set up and used properly. • Before setting up and using, read, understand, and follow all instructions as outlined below. When setting up vise: • Use proper size bolts, nuts, lock and flat washers, in all base mounting Holes. Never weld base of vise to any metal object. • Only hand-tighten swivel base lock down nuts at the sides of the vise.