User Manual

5 Reception quality and transmission speeds
56 / 90
4. To take over the modifications into the current configura-
tion leave the configuration mode by entering the command
exit (see page 27).
The following output appears:
Configuration changed, do you want to save (y)es
/ (n)o / (c)ancel ?
You now have the choice:
-
To transfer the new configuration into the current con-
figuration and to leave the configuration mode by
pressing the key „y“,
-
To discard the modification but to leave the configura-
tion mode anyway by pressing the key „n“ or
-
To not take over the modification into the current con-
figuration but to stay in configuration mode by press-
ing the key „c“.
Press the „y“ key to activate the looptest. The modification
of the parameter becomes part of the current configuration
and the WIMAN starts transmitting bit samples.
5.2 Test after a Radio Tower Installation with Syn-
chronisation
After all devices are correctly installed, a final test must be exe-
cuted. This final test checks if all devices are installed correctly
and whether a trouble free transmitting and receiving mode is
possible.
• Switch on the first WIMAN radio modem. Always begin
with the WIMAN determined as synchronization master.
• Radio test
-
If the synchronization Master is a WIMAN STAR or a
WIMAN LINE Master, conduct a loop back test from
a properly configured WIMAN ACCESS or LINE
Slave.
-
It the synchronization Master is a LINE Slave, conduct
a loop back test from its LINE Master.
• Check the X.21-interface by connecting the X.21-plug of
the Hybrid cable type-2 to the Router.