User Manual

2 The WIMAN Command Line Level
13 / 90l
2 The WIMAN Command Line Level
The operating system of the WIMAN radio modem has an inte-
grated command line interpreter ("Shell") for configuration of
the WIMAN. Input and output is visible on the input or output-
window of a PC terminal program (e.g. TELIX, ZOC).
So that communication between the terminal program and the
WIMAN can take place, the communication parameters of the
terminal program and the WIMAN must correspond.
The configuration of the WIMAN radio modem is executed with
instructions on the command line level (“Shell”). There is no
distinction between upper- and lower case characters (except for
passwords).
The command line level can be accessed via different interfaces.
Successful locking on the command line level is acknowledged
by display of the command line prompt. The factory setting of
the command line prompt is WIMAN II >.
The user may personalize the command line prompt (e.g.
DEVICE 1:).
2.1 Authorization Levels
The command line level has two different authorization levels
that differ in the number of changeable parameters. Therefore,
the WIMAN radio modem may be configured by diversely
qualified and permitted persons (e.g. user, Provider).
The last character of the command line prompt displays the au-
thorization level you are in at that time.
The authorization levels are represented as follows:
• Authorization level 1 WIMAN II >
• Authorization level 2 WIMAN II #
Each authorization level can be protected with a different pass-
word. However, a password for authorization level 2 is always
needed.