User Manual

2 The WIMAN Command Line Level
15 / 90l
2.3 Operation Modes
On the command line level, the following operating modes are
differentiated with respect to each authorization level:
• Command mode and
• Configuration mode.
In command mode you can view the accepted parameters of the
present configuration (current config) as well as give the ac-
cepted commands for this mode and authorization level (see
Chapter 2.6.1 on page 25).
In configuration mode you may change only the parameters al-
lowed for that specific authorization level.
The system software indicates these parameters as “new con-
figuration” (new config). You may render certified instructions
for this level and this mode.
Figure 4 shows how to switch between the different authoriza-
tion levels and operation modes.
pw password
[] optional
(n) Authorization level
en enable
Figure 4 Diagram of the different operating modes
serial connection /
Telnet
Reset pw
←
↓ [pw] ↑ exit ↑ exit
↓
Reset Config
←
pw
→
Command Mode
(1)
→
en pw
Command Mode
(2)
↓ config ↑ exit ↓ config ↑ exit
Config Mode Config Mode