User Manual

2 The WIMAN Command Line Level
17 / 90l
2.5 Configuration Parameters
The WIMAN radio modems are delivered with a factory-
installed standard setup. To adjust the WIMAN to your specific
requirements you can modify different parameters (depending
on the authorization level).
The configurable Parameters are classified into the following
groups:
• Parameter for the wireless interface,
• Parameter for the serial interface,
• Parameter for the network,
• Other parameters.
All parameter can only be changed in the configuration mode of
the appropriate level.
2.5.1 Parameter for the Wireless Interface
The following parameters affect the wireless interface and serve
to set up the network configuration. These parametersalso set up
countermeasures against possible disturbances in the operating
frequency band.
The parameter destination determines the destination address of
the WIMAN, to which all data will be sent.
Note:
This setting is only available on WIMAN LINE units and is not
used on WIMAN STAR and ACCESS units.
Authorization Level: 2
Preset value: 1
Scope: 0 ... 250
The parameter FTab determines the frequency-hopping pattern
between the 80 channels. Each WIMAN radio-modem comes
with a factory installed frequency-hopping pattern that cannot be
changed. However, it is possible to create a second frequency-
hopping pattern to be used in place of the standard one. In this
case the new pattern can be set with FTab.
Authorization Level: 2
Destination
FTab