User Manual

2 The WIMAN Command Line Level
20 / 90
would function perfectly and all other devices with the same
NetId and NodeId would be ignored.
Authorization Level: 1
Preset value: 0 (WIMAN Star)
Scope: 0 ... 250
The parameter RadioPower activates the normal operation or
switches into a low power mode (around 0 dBm, regardless of
the Region or Antenna setting). When there is only a small dis-
tance between a STAR and ACCESS the transmitting power can
be scaled down to avoid overriding of the input-stage.
Authorization Level: 2
Preset value: Normal
Scope: Normal, Low
The parameter Antenna specifies the type of antenna used with
the WIMAN and thus determines the specific settings (e.g.
transmit power) required for that type of antenna.
Authorization Level: 2
Preset value: 8mn360
Scope: 2mn360, 8mn360, 85pl76, 16pl27,
24pf20
In addition to the parameter Antenna, the parameter Region sets
the WIMAN radio to the specific settings required in that spe-
cific region (output power, frequency-range, etc.).
Authorization Level: 2
Preset value: depending on region
Scope: 1 valid for ETSI-compliant
operation
2 valid for FCC-compliant
operation
Note:
Incorret setting of the parameters 'Antenna' and 'Region' may
lead to non-permitted behaviour of the unit and will void the
right of operation !
If you are not sure which operation mode the WIMAN unit must
comply with, please refer to your local distributor or manufac-
turer of this system.
RadioPower
Region
Antenna