User Manual

2 The WIMAN Command Line Level

28 / 90

Note

Entering the command exit at the command line level (Shell)

will always allow you to leave the command mode. This proce-

dure ensures that modifications made in a higher authorization

level are saved.

The command Export makes it possible to export the configura-

tion parameter values into an ACSII-file. The Serial number of

the WIMAN as well as the encrypted passwords are put out, too.

The range of the parameter values depends on the authorization

level in which you are when issuing this command. At the end

of the configuration file, the passwords for the individual au-

thorization levels are exported in encoded form, excluding the

passwords for the authorization levels you have no access to.

Figure 6 shows a possible configuration file.

Figure 6 exported configuration file

The instruction <parname> <value> enables you to occupy the

defined parameter <parname> with the defined value <value>.

This is the "classic” command for adapting the WIMAN to your

specific requirements. This instruction can be executed in con-

figuration mode only!

The instruction save transfers the present configuration into the

non-volatile configuration. This instruction can be issued only in

the command mode.

The instruction Restore enables a transferring of the parameter-

values from the non-volatile configuration into the new configu-

ration. All modifications completed before are overwritten. This

instruction can be issued in the configuration mode only.

Attention:

Since the parameter-values of the non-volatile configuration do

not have to correspond with the values of the present configura-

tion, an operational disturbance can occur. This can happen due

Save

Restore

Export

<value>