User Manual

Wimberley, Inc. ©2018, All Rights Reserved Rev. 180325
Arched Recess
reliably grip cylindrical
objects such as small
flashlights and branches.
Foam Jaw Inserts
Grip delicate objects without damage.
The Plamp Clip
Thumbscrew Turn the thumbscrew to open or close the jaws of the
clip. Compared to typical spring-activated clips, thumbscrew activated
clip jaws allow for more finesse when holding delicate objects, as well
as much higher maximum clamping force when desired.
Clip Body
The clip is custom designed to hold
anything from the most delicate plant stems
to heavy reflectors and diffusers. It is made of
nearly unbreakable ST Nylon
Jaw opening band
This elastomer band puts tension on the clamp’s moving
jaw so that it opens when you loosen the thumbscrew. It
is made of weather/UV resistant EPDM
Special notches in the clip’s jaws grab the steel rim on reflectors and
diffusers, providing a secure, slip-free attachment (applies to typical cloth
reflectors/diffusers with steel perimeter hoop). This new feature is a drastic
improvement over other clips currently on the market.
The firm grip allows you to make precise adjustments to the angle of a reflector.
You can even hold diffusers cantilevered straight out above your subject
Important Feature
Reflector/Diffuser Notches
Package Contents:
• The Plamp Clip (Qty 1)
Connecting the Plamp Clip to your Plamp
1. Remove the old clip end from the
Plamp by firmly grabbing the Loc-Line®
segment next to the end segment that is
attached to the clip. Bend it sharply until
the segments pop apart (do not worry,
you will not hurt the Plamp).
2. To attach the new clip, forcefully press it onto the segment
that was previously attached to the old clip. It should snap into
place with an audible “pop”. It takes a substantial amount of
pressure to make this happen. It helps to place your fists be-
tween your knees, holding the mating pieces as close to the
connecting joint as possible. Squeeze your knees together
forcefully as you force the joints together with your hands. If
you are still having difficulty you can heat up the female socket
to facilitate the process (details be-
low).
Heating the female socket:
Heat some water to boiling or near-
boiling temperature. Warm the female
end of the segment for 30-60 seconds in
the hot water. Connect the segments by
pushing them together. Use the knee-
squeezing technique mentioned above if
needed. The segments should pop into
place fairly easily.
Wimberley, Inc. Phone: [phone]
1750 Broadway St Toll Free: 1-888-665-2746 (USA & Canada)
Charlottesville, VA
22902 USA www.tripodhead.com [e-mail]
5 Year Warranty – See www.tripodhead.com/warranty.cfm for complete details
Made in USA
PP-211
The Plamp II
Thumbscrew Clip