Components of furniture Please check the board number and the hole on the board 1 5 9 2 Left vertical plate 600×383×15mm 1 PC Bottom panel 400×383×15mm 1 PC Drawer right coaming 330×150×15mm 1 PC 13 Cabinet pull plate 370×70×15mm 1 PC 6 Right vertical plate 600×383×15mm 1 PC Drawer panel 400×305×15mm 1 PC 10 Drawer base plate 340×325×5mm 2 PCS 14 E Screw M4x20mm Back panel 600×370×15mm 1 PC 7 Drawer back plate 345×280×15mm 2 PCS 11 Drawer pull plate 315×70×15mm 1 PC 15 Drawer right coa
I Lock&Keys J Caster x5 2 PCS M Lock Latch K Screw 2'' N Caster Gasket 1 PC L Wood Dowel 4 PCS 1 PC M3.
"G" Hardware disassembly example
STEP 1 C M ⑬ C×2 M×1 STEP 2 G ① ② C C Please install as shown Note! The pre-drilled holes for locating the drawer slides are relatively small, look carefully.
STEP 3 ① ③ A A A ⑬ Screw the Cam Bolt first, then the Cam Lock and rotate until it locks A×4 STEP 4 ① ③ A ⑬ A A ② A×4
STEP 5 ④ A A A A ×4 A×4 STEP 6 C N C N C C N C N N ⑫ ⑤ C×15 N×5
STEP 7 J J J J ⑤ J×4 STEP 8 F ⑤ F F F×4
STEP 9 ⑧ ⑨ C ⑮ ⑭ Please install as shown C×8 STEP 10 ⑮ A1 ⑭ A1 A1×2
STEP 11 ⑮ ⑪ ⑭ STEP 12 A2×2 ⑦ ⑧ F F ⑨ Upper Drawer ⑦ ⑮ F F ⑭ Lower Drawer F×8
Lower Drawer Upper Drawer STEP 13 ⑦ ⑧ ⑦ ⑩ ⑨ ⑮ ⑩ STEP 14 l e tte H ⑧ r siz ⑭ e H A l e tte H A ⑯ ⑮ ⑨ ×4 r siz e H A A ⑥ Tips: Choose the holes and insert the Hanging Rods before connecting the drawer front panels ⑭ ×4 H×4 A×8
STEP 15 E D E ⑯ E D E ⑥ E×4 D×2 STEP 16 B I ⑯ ⑥ B×8 I×2
STEP 17 L ⑮ ⑥ ⑫ ⑭ L×1 STEP 18 K K K K J ⑫ J×1 K×4
STEP 19 ⑯ Pull out the sliding part of the drawer slide first, and the balls along with it to the front. Keep the drawer level and insert the drawer with the slides aligned Note! Failure to level may result in damage to the slides STEP 20 ⑯ ⑥ Pull out the sliding part of the drawer slide first, and the balls along with it to the front.