Fire Pit User Manual

YOUR MODEL 1300 SHOTGUN.

CAUTION: WHENEVER HANDLING ANY SHOTGUN FOR THE

PURPOSE OF REMOVING OR INSTALLING A CHOKE TUBE,

MAKE ABSOLUTELY CERTAIN THE GUN IS FULLY

UNLOADED AND THE ACTION IS LOCKED OPEN. NEVER

ATTEMPT TO REMOVE OR INSTALL A SHOTGUN CHOKING

DEVICE ON A LOADED FIREARM!

DO NOT FIRE THIS SHOTGUN WITHOUT HAVING THE

WINCHOKE CHOKE TUBE INSTALLED. PERMANENT

DAMAGE MAY RESULT TO THE THREADS.

Failure to follow these warnings may cause damage to

your gun and cause injury to yourself and others.

TUBE REMOVAL —

1. Place the safety in the “on safe” position and fully

unload your Model 1300.

ALWAYS UNLOAD YOUR MODEL 1300 COMPLETELY.

INSPECT THE CHAMBER, MAGAZINE AND FEED

MECHANISM TO MAKE SURE THEY DO NOT CONTAIN

ANY SHELLS.

2. Open the action.

3. Use the WinChoke spanner wrench to loosen the tube,

turning it counterclockwise (Figure 8). Finger twist the

tube the rest of the way out of the barrel.

TUBE INSTALLATION —

1. Place the safety in the “on safe” position and fully

unload your Model 1300.

ALWAYS UNLOAD YOUR MODEL 1300 COMPLETELY.

INSPECT THE CHAMBER, MAGAZINE AND FEED

MECHANISM TO MAKE SURE THEY DO NOT CONTAIN

ANY SHELLS.

2. Open the action and lock it open as

explained previously.

3. Before installing a tube, check the internal choke tube

threads in the muzzle, as well as the threads on the

WinChoke choke tube to be sure they are clean.

Lightly oil the threads with a quality light gun oil.

FIGURE 8

Use the spanner tool to remove or

tighten WinChoke tubes.