PACT Walt Sleeve TILT SLEEVE 1/4 BUBBLE TO THE OUTSIDE (Installation level) (Do not over tilt to the outside) LEVEL SLEEVE FROM LEFT TO RIGHT DO NOT TWIST OR DISTORT SLEEVE WHEN INSTALLING (Shim sleeve as needed to eliminate bending or distorting sides during installation) ATTACH SLEEVE TO WALL (Secure sleeve to wall with appropriate wall anchors (screws, nails, etc.)) (Anchor sleeve to wall only through sides of sleeve) (DO NOT put holes in bottom of sleeve.Except for drain kit DK90OD orDK9001D.
PACT WALL SLEEVE INSTALLATION INSTRUCTIONS The wall sleeve must be installed before the air conditioner or heat pump chassis can be stein place. Read the instructions thoroughly before proceeding. When 230/208 volt units are to be installed, the power supply may be either cord connected or permanent wiring. Permanent wiring may be done through the hard wire junction box, or the accessory sub base. When 265 volt units are to be installed, the power supply must be permanent wiring.
KIT ACCESSORIES Drain Kit Ar indoor/outdoor drain kit is available as an accessory item. When a drain kit is to be installed, do so before installing the wall sieve in the wall. See the drain kit for actual installation instructions. Bask, Leveling Lees, Man Duct, anp Hydroponic Heat Kits Installation of these kits requires drilling of mounting holes on both sides of the wall sleeve. The minimum required clearance distance between the wall sleeve and wall is shown in Table 1.
PER-INSTALLATION CONSIDERATIONS Before proceeding with the sleeve installation, ensure the following guidelines for locating the wall opening and sleeve are met: » The wall opening must be the correct size, See Figure 1 for wall sleeve dimensions and Figure 2 for minimum wall opening size. * The wall sleeve will ends to be installed with minimum clearances to the floor and adjacent walls. Minimum projections of the slave into and aut of the room will also have to be met.
Figure 9 Panel Removal WALL SLEEVE INSTALLATION After the wall opening is checked and approved for location, size, and clearances, complete the following to install the wall sleeve. 1. Remove the outside enclosure panel from the wall sleeve. 2. Slide the wall sleeve into the wall opening. Do not distort the cabinet shape to fit the wall opening; the unit chassis must fit snugly and uniformly into the wall sleeve. 3.
| DRAIN KIT INSTALLATION INSTRUCTIONS (Combination Drain Kit...for outdoor or indoor sleeve drainage.) The installation and servicing of the equipment should be done by qualified experienced technicians. Description This kit is used to control condensate from the unit.
Installation for Indoor Use The components of the wall sleeve drain kit for indoor use are shown in figure below. These components must be installed prior to the installation of the wall sieve. f WALL {i Detail A 1. Locate an area on the wall sleeve that will be inside the room when the sleeve is installed. If a sub base is installed, locate the kit a minimum of 3 1/2" from the front flange of the wall sleeve. This clearance will provide adequate clearance for the sub base. 2.
PACT Standard Louvered and Installation Instructions Architectural Outdoor Grilles Standard Louvered Grille NOTE: A baffle kit must not be used with a standard louvered grille on any PACT installation. Before installing the grille, remove the cardboard stiffener and rear enclosure panel from the wall sleeve, These items can be removed from inside of the building. The sleeve stiffener must be taken out before the rear sleeve enclosure panel can be removed from the sleeve.
Architectural Louvered Grille NOTE: Some PTA's may include factory-installed baffles — on the outdoor coil. Remove theses baffles before installing { B) the architectural grille. 1. Remove the cardboard sleeve stiffener and the rear enclosure of the sleeve as described on page Install the four threaded studs (B, Figure 4) into the threaded openings on the inside face of the grille. | Fay 3. Manipulate the grille out through the rear sleeve opening (p) ing ing the plastic handle provided.
