OWNER’S OPERATING & MAINTENANCE MANUAL For Models: 6980-6988 & 6990-6998 PLEASE DO NOT DISCARD THIS MANUAL! KEEP FOR FUTURE REFERENCE AND TRAINING
TABLE OF CONTENTS/WARRANTY IMPORTANT SAFETY INFORMATION........................................................................................ 2-3 ASSEMBLY INSTRUCTIONS......................................................….............................................. 4 OPERATING INSTRUCTIONS............................................................................................…...... 5-7 GENERAL MAINTENANCE....................................................……........................................
IMPORTANT - PLEASE READ FOR PRODUCTS WITH POWERED OPTIONS (Heat, Massage, etc...) Read all instructions before using this product. IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS To reduce the risk of electric shock when using an electrical appliance, basic precautions should always be followed, including the following: DANGER - Always unplug this product from the electrical outlet before cleaning, maintenance or when putting on or taking off parts. WARNING: 1.
IMPORTANT - PLEASE READ GROUNDING INSTRUCTIONS: This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
ASSEMBLY INSTRUCTIONS BACK ASSEMBLY INSTRUCTIONS 1. Carefully remove back assembly and chair frame from carton. Note: Handle with care when removing chair from box. This will ensure that no damage is done to the cables and/or wiring that connects the back to the chair. 2. Lock ALL (3) total-lock casters on chair base. (see Lock/ Unlock Casters page 6). NOTE: Make sure the footrest is in closed position before installing the back. FIG. 1 3.
OPERATING INSTRUCTIONS RECLINING THE CARE CLINER & TRENDELENBURG (Figures 3 & 4-1 are attendant operated ONLY) 1. LEGREST ELEVATION: From the "SEATED UPRIGHT" position, grip the Legrest Handle and pull towards the back of the chair until handle stops (FIG.1). 2. The back can be adjusted to infinite recline positions. To do so, lift the Back Release Handle, then position the chair Back to the desired position and release the handle (FIG.2).
OPERATING INSTRUCTIONS (cont'd) LOCK/ UNLOCK CASTERS (Total-Lock vs. Directional) 1. Total-Lock casters will lock wheel and swivel mechanism by using your foot & pushing down on the tab. Both front and the right-rear casters are Total-Locks. These are identified with lighter gray tabs. Directional caster is used to help steer the chair (Left rear only). The tab locks the swivel mechanism; The wheel does not lock on this caster. It is identified with a darker gray tab. (FIG. 1) FIG. 1 FIG. 2 2.
OPERATING INSTRUCTIONS (cont'd) HEAT & MASSAGE OPTIONS Control is located on the inside of right arm of chair. HEAT OR HEAT ONLY MASSAGE Heating: Push HEAT button - See indicator light on switch 3 Lights = High Heat / Bright Light 2 Lights = Medium Heat / Med Light 1 Lights = Low Heat / Dim Light No Light = HEAT OFF Allow 5-8 minutes for back and seat to warm to desired TEMP. setting. Heat will automatically shut off after approximately 60 minutes.
GENERAL MAINTENANCE ADJUSTING GAS SPRING NOTE: Tension or "ease of movement" of the gas spring is set by factory and cannot be changed. 1. Using 2 people (RECOMMENDED), tilt the chair over onto the Left side and locate the Gas Spring (FIG. 1). Loosen the 11/16" hex nut on the Gas Spring located near the bottom-front of the chair. (FIG.2) FIG. 1 2. On the opposite end of Gas Spring, remove the Bow-Tie Cotter Pin and Clevis Pin - (save the 2 plastic Clevis Pin bushings) (FIG.
6980 & 6990 SPECIFICATIONS 6980 - Specifications Seat Height ...........................23.5" to Footrest Plate...........16.5" Seat Width...............................21" Overall Height ........................52.5" Overall Width (Trays Down)...34.5" (Trays Up)........44" Back Height Above Seat......32.5" Seat Depth...........................21.5" Weight .................................167 lbs. Maximum Weight Capacity....350 lbs. 6990 - Specifications Seat Height ...........................23.
NOCTURNAL CARE CLINER OPTIONS Heat & Massage HM .....................................Heat & Massage HT ..............................................Heat ONLY FACTORY INSTALLED ONLY IV Pole & Attachment Oxygen Tank Holder IV................................ IV Pole & Attachment O2.....................................Oxygen Tank Holder Side Cushion Armrest Covers AC00..............................Armrest Covers (Pair) SC00............................................
LIMITED WARRANTY TERMS Winco Mfg., LLC. warrants this product to be free of manufacturer’s defects in material and workmanship, provided that the product is used according to normal operating conditions and proper maintenance intended by manufacturer. This warranty is available only to the original retail purchaser, is non-transferable and commences on the date of retail sale; proof of purchase required. LIMITED ONE YEAR COMPLETE PRODUCT WARRANTY: Winco Mfg.