Instructions ULPSS15B2W/E Manual

INSTALLATION INSTRUCTIONS FOR 2-WIRE

AUTO START CONTROL CONVERSION

The following instructions are provided to convert the ULPSS15B4W/E

from a special 4-wire start system to a standard 2-wire Auto Start Sytem.

Items required:

WINCO Conversion Kit # 16448-005 Auto Start (for ULPSS15B2W/E)

T25 Torx Screwdriver

7/16” End Wrench or Socket & Driver

PROCEDURE

1. Move the left hand toggle switch “A”

to the “STOP” position.

2. Remove the battery negative (-)

cable if the battery is installed.

3. Unplug the wiring harness “D”.

4. Remove the two bolts “B” and remove

the circuit breaker cover panel “E”.

5. Remove the 4 torx screws “G” from the

tower assembly.

6. Remove the 4-wire controller “C” by

pulling it forward.

7. Install 2-wire controller “F” by pushing

the controller back into position.

8. Re-install the 4 torx screws “G”.

9. Re-connect the wiring harness “D”.

PAGE 1
INSTALLATION INSTRUCTIONS FOR 2-WIRE AUTO START CONTROL CONVERSION The following instructions are provided to convert the ULPSS15B4W/E from a special 4-wire start system to a standard 2-wire Auto Start Sytem. Items required: WINCO Conversion Kit # 16448-005 Auto Start (for ULPSS15B2W/E) T25 Torx Screwdriver 7/16” End Wrench or Socket & Driver PROCEDURE 1. Move the left hand toggle switch “A” to the “STOP” position. 2. Remove the battery negative (-) cable if the battery is installed. 3.
PAGE 2
10. Locate the 2-wire white connector, hanging loose on the right hand side of the control tower. Attach it to the matching connector “H” on the bottom of the new controller “F”. 11. Replace the circuit breaker cover panel “E” and re-install the 2 bolts “B”. 12. Remove the right side door. 13. Locate the 2-wire white connector on the right side of the engine. Unplug the white connector and tie back if necessary. See picture below.
PAGE 3
14. Replace the right side door. 15. Re-attach the battery cable if done so earlier. 16. Remove the the operators manual part # 60706-206 for model ULPSS15B4W/E from the literature package and replace it with operators maual part # 60706-207 for model ULPSS15B2W/E. This replacement manual contains the proper information for installation and operation of a 2-wire auto start system. The customer must have this manual in order to start and operate the unit after the installation of the new engine control. 17.