User manual

Memory
In another menu, you will see the memory configuration, as shown in the
following screen.
XMS stands for Extended Memory Specification (above a memory capaci-
ty of 1 MB).
LPT1 mode
As of the 80486DX2 system, the LPT1 parallel interface can be run in
ECP, EPP V1.7 and EPP V1.9 modes as well as in standard mode. You
make the selection in the following screen:
If you are using an WN printer, you must set standard
mode.
Power management
The 80486DX2 system recognizes different operating mode settings (po-
wer management). If you set “NO”, the CPU is in normal mode; in other
words, the system is working at full power consumption. If you set “YES”,
you enable power management.
Memory 640 KB
XMS 1408 KB
(8) Prev
(2) Next
LPT1 Mode
Standard
(8) Prev (6) Incr
(2) Next (4) Decr
PowerMan Yes
(8) Prev (6) Incr
(2) Next (4) Decr
BIOS setup
GB - 86