USE AND CARE MANUAL GAS COOKTOP MODELS: CTG304D, CTG305D, CTG365D IMPORTANT: Before beginning use please read these instructions completely and carefully. INSTALLER: Leave this owner’s manual with the cooktop. OWNER: Please retain this manual for future reference. CNP INDUSTRIES, INC. P.O.
Dear Customer, Thank you for selecting a Wind Crest Gas Cooktop. By following the procedures and recommendations in this manual the cooktop should give you many years of service. The top is produced from high quality stainless steel, which is very durable but does require some care to maintain its beauty. Using cleaners and polishes that are designed for use on stainless steel will aid in the maintenance of your cooktop and keep it looking new.
1. For your safety: -Do not obstruct the flow of combustion and ventilation air to the unit. -Keep appliance area clear and free from combustible material. 2. Never use this product for warming or heating a room. 3. An approved gas regulator is supplied and should be used with this appliance. POWER SUPPLY – Requires a 120 VAC, 60 HZ, 15 Amp single-phase circuit for all models. A three prong grounded receptacle is required.
SAFETY PRACTICES TO AVOID PERSONAL INJURY IMPORTANT SAFETY INSTRUCTIONS THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: C. Use high range settings on range only when necessary. Heat oil slowly on low to medium setting. A. Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. D. Do not leave range unattended when cooking. E.
Do not repair or replace any part of the appliance unless specifically recommended in this manual. All other servicing should be referred to a qualified technician. When using the cooktop: DO NOT TOUCH THE BURNER GRATES OR THE IMMEDIATE SURROUNDING AREA. Areas adjacent to the burners may become hot enough to cause burns. Children should not be left alone or unattended in an area where appliances are in use. They should never be allowed to sit or stand on any part of the appliance.
California Proposition 65 – Warning: Burning gas cooking fuel generates some by-products which are on the list of substances which are know by the state of California to cause cancer or reproductive harm. California law requires businesses to warn customers of potential exposure to these substances. To minimize exposure to these substances, always operate this unit according to the instructions contained in this booklet and provide good ventilation.
Controls & Burners Model CTG304D (Grates not shown) 4 3 2 4 3 2 1 1 1 – Right Front Burner Control 9,000 BTU/HR 2 – Left Front Burner Control 15,000 BTU/HR 3 – Left Rear Burner Control 12,000 BTU/HR 4 – Right Rear Burner Control 15,000 BTU/HR Model CTG305D (Grates not shown) 5 4 5 4 3 2 1 3 2 1 1 – Right Front Burner Control 9,000 BTU/HR 2 – Left Front Burner Control 15,000 BTU /HR 4 – Left rear Burner Control 12,000 BTU/HR 5 – Right Rear Burner Control 9,000 BTU/HR 3- Center Burner Control
Model CTG365D (Grates not shown) 5 1 3 2 1 – Left Rear Burner Control 12,000 BTU/HR 2 – Left Front Burner Control 15,000 BTU/HR 4 3 – Center Burner Control 18,500 BTU/HR 4 – Right Front Burner Control 9,000 BTU/HR 5 – Right Rear Burner Control 15,000 BTU/HR Control Knob & Graphic OFF HIGH HEAT LOW HEAT ULTRA - LOW HEAT CENTER BURNER ONLY 8
CONTROL OPERATION Each burner has an individual control knob allowing infinite heat selection between high and low. - 9,000 Btu/hr burner adjusts to 1300 Btu/hr Low 12,000 Btu/hr burner adjusts to 1600 Btu/hr Low 15,000 Btu/hr burner adjusts to 2100 Btu/hr Low 18,500 Btu/hr burner adjusts to 4100 Btu/hr Low and 500 Btu/hr Ultra-Low The control knobs are plated metal and can be removed (by pulling straight upward) for improved cleaning. Be sure the control is in the OFF position before removing a knob.
Electronic Ignition Each burner has an igniter that sparks when the burner is turned on, or during re-ignition if the flame is extinguished. When a flame is present the igniter will stop sparking. If a cross draft is present the flame can be affected and some sparking can occur. This is normal. The igniter can get dirty due to normal cooking splatter or spills. This may cause nuisance sparking. The igniter can be cleaned by using a Scotch Brite cleaning pad to clean the igniter disk.
Grates The grates are porcelain enamel coated cast iron. Non-abrasive cleaners are preferred. Use a hot or warm water and detergent solution. Mild abrasive cleaners, such as Bon Ami®, are acceptable. After cleaning always rinse and dry immediately. If grates are extremely dirty, a Scotch Brite pad will aid cleaning. Acidic and sugar-laden spills attack the porcelain – remove soil immediately. Note: The grates will show discoloration, crazing, and chips due to high heat exposure. This is normal.
NOTES 12
