Product Manual

8
5. Control system
5.1 The control interface of the system is inside the shell. It is an
interface with 8 frames. It can be programmed and read and written by
opening the shell connection interface.
Serial port section
1
2
3
4
5
6
7
8
Features
3V3
G
Burnsck
BurnDIO
blank
G
MCU-TX
MCU-RX
6. Installation Notes
6.1 Use 4 M4 anti-theft screws to connect the IOT shell and the back
splint to the front end of the whole vehicle riser, and then use 2 M6
anti-theft screws to fix through the splint and riser.
6.2 Insert the cable terminal of the motor controller into the IOT
controller connection port and fasten the interface.
7. Software function
7.1 restart function
7.2 car search function
7.3 backup point charging management function
7.4 throttle function
7.5 self-diagnosis function
7.6 speed limit function