User`s guide

Spa Side Controls
The spa side is where you will control all of the electrical components designed for regular usage.
The diagram below lists all of the functions of the controller and what purposes they serve.
A) LCD Screen... The LCD screen will always display the current water temperature when the spa is not in use.
The only time the screen does not read the current temperature is when the thermostat is being set up or down
with the Warm or Cool buttons to set the desired new temperature. If any other reading appears it is an error
message and you should refer to the Error Message Chart in the Troubleshooting section of this manual. Use the
chart to diagnose what the error is and then call your Wind River Spas service center.
B) Cool Button... The cool button simply allows you to turn down the spas set temperature. The coolest
the spa can be adjusted to is eighty degrees Fahrenheit.
C) Warm Button... The Warm Button on the spa allows you to turn up the spas set temperature. The
warmest the spa can be adjusted to is one hundred and four degrees Fahrenheit.
D) Heat Light... This light indicates when the spa is actually heating. When the light is orange it means
the spa is not heating. When the light is red that indicates that the spa is heating.
E) Jets 1 Button... The Jets 1 Button will turn on the pump that runs up to half of the jets in a two-pump
model and all the jets in a single pump model. This button has three stages to cycle through. The first time you
push the button it will turn the jet pressure on low. The second time you push it, it will turn the pressure from low
to high. The third time turns the pressure off returning to the default filtration modes only.
10
Spa Features
D
A
B
C
E G J
HF I
K
L
M