User`s guide

F) Jets 1 Light Indicator... This light simply indicates when the jet pump is engaged. When the light is
orange the pump is off. When the light is red the pump is on. If the light is red indicating the pump should
be engaged but there is no jet pressure refer to the troubleshooting section of this manual.
G) Jets 2 Button... The Jets 2 Button will turn on the pump that runs up to half the jets in a two pump
model. This button has three stages to cycle through. The first time you push the button it will turn the jet
pressure on low. The second time you push it, it will turn the pressure from low to high. The third time turns
the pressure off returning to the default filtration modes only.
H) Jets 2 Light Indicator... This light simply indicates when the jet pump is engaged. When the light is
orange the pump is off. When the light is red the pump is on. If the light is red indicating the pump should
be engaged but there is no jet pressure refer to the troubleshooting section of this manual.
I) Cleanup Mode Button... The Cleanup Mode Button will turn all of the spas jet pumps on high speed
for five minutes only. This function is best used for mixing chemicals into the water at the end of each use.
(see Chemical Maintenance in the Operating Procedures section of this manual)
J) Light Button... This button will turn the light on and off. Some models have color changing LED light
upgrades. If your model is equipped with LED than every time you turn the light off and on it will change to
a different light pattern, (strobe, fade, solid, etc.). You must cycle through the different functions within ten
seconds for them to change. If you turn the light off and leave it off for over ten seconds the function returns
to the previous setting.
K) Light Indicator... Like the Jets Light Indicator this light will glow orange when the light is off and red if
it is on. If the light is red indicating that the light should be on but there is no light call your Wind River Spas
service department.
L) Remote Panel... The Remote Panel allows you to operate the jets and lights from the opposite end of
the spa than your main Spa Side Controls.
M) Floating Remote... The Floating Remote is a great option in your Wind River Spa as it allows you to
operate the jets and the lights from anywhere within the range of the IR sensor. Always store the floating
remote indoor and remove it from the spa water when it is not in use. If the remote is left in the spa it may
float over into the Filter Skimmer and restrict the flow of the water through the filter. The fact that the remote
operates through infrared and is not attached to the spa leaves it susceptible to many types of damage,
because of this it is only covered under the manufactures warranty unless otherwise specified in your written
warranty from the time of purchase.
11
Spa Features