Specifications

Operation

2.1 Functional description

The VarioWIN pellet central heating boiler and the Modular Energy System MES or the REG standard control

combine to form a perfect unit. The VarioWIN automatically fires when the control system signals a heating requi-

rement. Following „purging“ (safety function), ignition starts and the pellet metering auger switches on. The

burner pot is automatically filled with pellets. When flame formation has been detected (by the thermocontrol

sensor), the boiler enters flame stabilisation mode and then control mode (modulation mode) and keeps to the

specified boiler temperature setpoint (between 60 °C and 75 °C). The boiler enters burnout mode if the output

drops below the minimum nominal thermal output or no heating requirement is signalled by the control system.

The blower continues to run until the burner pot has cooled down. Therefore, do not switch off the electricity

supply to the device too soon.

2.1.1 VarioWIN Premium

Manual cleaning:

The heating surfaces are cleaned manually using the cleaning lever. The cleaning residues from the heating

surfaces and the combustion residues from the burner pot drop into the ash pan or ash pan space.

VarioWIN Premium-D with direct pellet feed and extraction port for mounting a year-round pellet con-

tainer

Direct pellet feed transports the pellets from a sheet steel tank or self-build pellet store via a rotary feeder to

the burner pot.

2.1.2 VarioWIN Exklusiv

Automatic cleaning:

Fully automatic heating surface cleaning:

A motor moves the heating surface cleaning system vertically and the heating surfaces remain clean.

Fully automated ash compactor:

The fully automated ash compactor uses a motor and pressure plate to compress the ash in the ash container.

This makes the emptying intervals up to 3 times longer.

VarioWIN Exklusiv-S with 41 kg pellet reserve supply container

The reserve supply container is loaded by hand.

VarioWIN Exklusiv-P with pneumatic pellet feed

The pellet feed uses a maintenance-free suction turbine to fill the VarioWIN reserve supply container fully auto-

matically with pellets from a pellet storage room or storage container. The pellet feed is switched on by the

lower fill level switch (proximity switch) in the reserve supply container or at the end of the enable time or the

beginning of the start time, and runs for as long as the reserve supply container is full. Filling is not started if

the boiler is in heating operation or the feed has been blocked by the control unit (outside the enable time, e.g.

at night). If the boiler is operating when filling is necessary, the boiler switches to burnout mode.

Switching between suction probes 1, 2 and 3 is fully automatic. The system changes to the next suction probe

after the reserve supply container has been filled a certain number of times. This means the storage room is

emptied as evenly as possible.

VarioWIN Exklusiv-D with direct pellet feed and extraction port for mounting a year-round pellet con-

tainer

Direct pellet feed transports the pellets from a sheet steel tank or self-build pellet store via a rotary feeder to

the burner pot.