User's Manual

Confidential Page 6 8/26/2004
2210 O’Toole Ave. #200, San Jose, Ca. 95131
Tel: [phone] Fax: [phone]
Step 7:
Mute/un-mute the microphone during talking.
User can mute/un-mute the microphone temporally by depressing volume up
button for about 3 seconds. If the microphone is muted, to un-mute the
microphone, user can depress either volume button for 3 seconds.
Step 8A:
Using voice dial.
Press the talk button when headset is not on call, voice prompt will be heard,
after the prompt, speaker the contact’s name, then phone will dial out.
Note:
Not all phone support voice dial feature, also phone must be set up
properly in order to user voice dial function.
Step 8B:
Dial last dialed number from headset.
Depress either volume button when headset is not on call for about three
seconds, this will enable phone to dial the last dialed number.
Another way to active last number redial is to press both volume up and
volume down button at the same time.
Note:
Not all phone support last number redial feature.
Step 9:
Enable or disable LED light tube ring indicator.
Press the talk button and volume button at same time will enable light tune
ring indicator, or disable it if it’s enabled before, it’s a toggle function.
Note:
Light tube ring indicator are only available on selected model, and may
consumes more current when this feature is enabled.
4. Summary of the LED display
No display
Headset is in idle mode
If blue LED is working, means battery is fully
If amber LED is working, means battery runs low
LED flashes at 1-seconds interval
Headset is in standby (connectable) mode
LED flashes twice quickly at 1-seconds interval
Headset is trying to make an audio connection to phone. This most
probably will happen when user wants to make a voice dial.