User Manual

Confidential
This document contains confidential information, trade secrets, and copyrighted expressions that are the property of
Windigo Systems. 2210 O’ Toole Ave #200, San Jose, CA95131 Tel: [phone] Fax: [phone]. Any disclosure,
reproduction, sale or license of all or any part of the information or expression contained in this document is prohibited
by California law and the United States copyright law, and may be subject to criminal penalties. If you are not an
employee of the Windigo Systems, or otherwise authorized in writing by Windigo Systems to possess this document,
please contact Windigo Systems immediately at the address above.
Powering OLED Headset
To turn on the headset
Press and hold the Talk button for 4 seconds. The “On…” will be displayed on the screen and you will
hear a tone. The headset will then be placed in “ Standby” mode and it will be ready to make and
receive calls.
To turn off the headset
When the headset is on, press and hold the Talk button for 4 seconds. The “Off…” will be displayed on
the screen, and you will hear the tone. The headset will then be switched off.
Pairing OLED headset to your mobile phone
Pairing is the process of linking the headset with your Bluetooth mobile phone. Before you use the
OLED headset with your mobile phone, you must pair both devices. After pairing is completed, you can
use the headset only with the paired mobile phone. If you wish to use the headset with a different
mobile phone, you must redo the pairing process with the new mobile phone. In this case, the headset
will no longer work with the previous mobile phone.
Before you commence pairing the headset, ensure that the battery is fully charged.
To pair the device
1. With the headset turned off, press and hold the TALK button for 5 seconds. “Pairing…” will be
show on the screen, and you will hear a tone.
2. Release the TALK button. The headset is now in Pairing Mode.
3. Turn on the mobile phone and place it within 10 feet of the headset.
4. Initiate the device discovery feature on the mobile phone. Refer to the mobile phone user guide
for instructions for initiating this feature.
5. When prompted by the mobile phone, enter the headset pin code “ 0000” . When pairing is
completed, the “Ready” will be shown on the screen.
To cancel pairing mode
Whilst you are in pairing mode, you can cancel the pairing process and turn off the headset.
Press and hold the TALK button for 3 seconds. The “Off…” will be displayed on the screen and you will
hear the tone.
Turn on the OLED display
With the OLED display turned off, press Talk button, Volume + button, or Volume – button will turn on
the OLED display.
Showing Caller ID and Caller Name
You can disable and enable the Caller ID/Name display function so that others cannot see your caller
ID showing.
To show the caller ID and caller Name (if supported by the phone)
With the caller ID display enabled, the caller ID (CID) and caller name will be displayed on the screen
whenever there is an incoming call.
With the caller ID display disabled, “ CID blocked” will be displayed on the screen when there is an
incoming call.