Installation Guide

[e-mail] 12.07.18
|
92-WB-SKF-01
INSTALLATION GUIDE: SINGLE CONTROL KITCHEN FAUCET
TURN OFF WATER SUPPLIES.
Ensure mounting surface requirements are
as follows:
• Single Hole Mounting: (Ø 1-3/8” Min to
Ø 1-5/8” Max)
• With Spray - Hole: 4" on center, (Ø 1-3/8”
Min to Ø 1-5/8” Max)
1
SIDE SPRAY HOSE INSTALLATION:
(IF EQUIPPED)
• Mount Spray Hose Holder onto sink and
secure with Hose Holder Nut.
• Insert Spray Hose into Hose Holder.
• From bottom side of sink, insert end of Spray
Hose through center mounting hole of sink.
• Assemble Spray Hose to Faucet and tighten.
(DO NOT OVER TIGHTEN CONNECTIONS).
2
MOUNT UNIT ON KITCHEN SINK.
Assemble and secure mounting washers and
nuts. (DO NOT OVER TIGHTEN
MOUNTING NUT).
3
ASSEMBLE WATER SUPPLY LINES.
Caution: Use wrench or pliers to hold faucet
inlet adapters when tightening supply line
nuts to prevent twisting copper tubing or
damaging solder joints.
5
PULL OUT SPRAY CONNECTION:
(IF EQUIPPED)
If your faucet is equipped with a pull out
spray, assemble “Braided Spray Hose” to
“Hose Quick Connect”.
CAUTION: Make sure Hose is properly
engaged and secure in Faucet Hose Quick
Connect. Assemble Hose Weight to Spray
Hose.
4
3
2
Accepts a 3/8”
Compression
Fitting
*SUPPLY STOPS NOT INCLUDED
1
5
4
1
3
8
"
MIN
1
5
8
"
MAX
4”