Installation Guide

HEX WRENCH
HANDLE BUTTON
H
EX
W
RENCH
LE
BU
TTO
N
CARTRIDGE CAP
RETAINING RING
CARTRIDGE
VALVE CARTRIDGE STOP
ADJUSTMENT RING STOP
INSTALLATION GUIDE: SINGLE CONTROL KITCHEN FAUCET
[e-mail] 12.07.18
|
92-WB-SKF-01
CARTRIDGE VALVE REPLACEMENT:
TURN OFF WATER SUPPLIES.
Should you need to replace the Valve Cartridge,
please follow the steps below.
• Remove Handle Button.
• Remove Handle using a Hex Wrench.
• Remove Valve Cartridge Cap Nut and
Retaining Ring.
• Replace Cartridge.
• Reassemble in reverse order.
9
HOT LIMIT STOP ADJUSTMENTS:
The Hot Limit Stop is a device that is used to limit
the Cartridge travel to the extreme hot position.
• Remove Handle using a Hex Wrench.
• Remove Hot Limit Adjustment Ring from Valve
Cartridge.
• Turn Valve on and adjust to maximum desired
water temperature.
• Reposition Hot Limit Ring so that the Ring Stop
touches the Cartridge Stop. This will prevent
the Valve Stem from rotating any further
towards the full hot position.
• Re-assemble Handle.
8
TURN ON WATER AND FLUSH
THE SYSTEM.
Remove Spray Wand or Aerator from faucet and
flush water through faucet to remove any line
trash. Assemble Spray Wand and run water
through faucet while checking for leaks at all
connections.
6
CONFIRM PROPER INSTALLATION
Check for leaks and proper operation of faucet.
7
CARTRIDGE VALVE REPLACEMENT
9
HOT LIMIT STOP ADJUSTMENTS
8
6
CALIFORNIA PROPOSITION 65:
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information go to www. P65Warnings.ca.gov.
Wash hands after installation, repair, or removal of this product.