Operating instructions

Operations

Set-up and Operation

1. Upon removing your new mini-extractor from the

box, loosen the latch at back end of the machine

that secures the recovery tank to the solution tank.

Remove the recovery tank from the solution tank.

2. Pour clean, hot water to the indicated fill line of the

solution tank. To avoid possible tank distortion,

water temperature must not exceed 140 F (60C).

3. Add a non-foaming cleaning solution concentrate,

for use in hot water extractors at the proportions

noted on the container (See list below), into

solution tank.

4. Place the recovery tank back onto the solution tank

and refasten the latch.

5. Plug the power cord into grounded outlet (See

GROUNDING INSTRUCTIONS).

6. Connect the vacuum and cleaning tool hoses to

the extractor. This unit is equipped with an 1/8"

male quick connect for solution hose attachment

and a 1" ID vacuum hose hookup. Insure that the

female solution hose coupler is securely locked

onto the male coupler on the extractor.

7. Turn switch ON. This switch operates both the

vacuum motor and the water pump. NOTE: The

pump is an oscillating pump and should not be run

dry for extended periods of time. This may cause

damage to your pump, therefore voiding your

warranty.

8. Squeeze the solution lever on the cleaning tool to

spray cleaning solution and place the vacuum

head on the surface to be cleaned. Normally,

chemical is applied on the push stroke while

vacuuming is done on the pull stroke. For heavily

soiled carpets the hand tool may be used in the

scrubbing manner, applying chemical in both the

push and pull stroke. Always finish up an area with

a vacuum pull stroke.

9. When cleaning, be sure to monitor the level of

recovered solution in the recovery tank. When the

solution reaches the FULL mark, shut off the

extractor, loosen the latches and empty the

recovery tank.

NOTE: Dispose of waste in a proper manner which

would not violate any Local, State or Federal law.

86221950 MINI-EXTRACTOR