Operating instructions

21
Operations
2. Release intermittent trigger switches or turn off
continuous setting on solution switch
approximately 1 foot before ending cleaning pass.
3. Push down on handle to raise vacuum shoe and
brush before moving to the next cleaning pass.
Overlap brush contact area approximately 1 inch.
4. During operation, observe the following: The
Admiral is equipped with clear internal covers to
facilitate operator viewing of dirty solution and
vacuum air flow.
During operation, observe the vacuum intake
cover. Large amounts of water or foam entering the
vacuum system can damage the vacuum motor.
If you notice either condition, shut down the
machine immediately. Empty recovery tank and/or
add defoamer to recovery tank.
5. Use right side of machine for cleaning against
walls.
1ft.
(30cm)
86401310 Operators Manual - ADM8 115V