Operating instructions

28
Maintenance
Use Gear puller to remove pad driver from motor shaft.
Take care not to misplace motor shaft key.
Install new pad driver, motor shaft key, spacer, washer
and bolt. Then install pad lock keeper, pad and pad
lock. Turn deck assembly over onto pad.
Reattach wires to motor and connect motor wire
harness to frame harness. Tie wires in place. Set
actuator barrel by rotating barrel up or down to set
barrel at 5-3/16 ±1/8 from bottom of frame to bottom of
barrel.
Reattach deck assembly to frame. Install actuator
barrel on to spring retainer bars. Lift bottom of deck
using your hand to align hole for clevis pin. Install clevis
and rue ring.
Turn machine on, raise deck, drive machine check that
machine is working properly. If not recheck actuator
barrel and reset again if needed.
86345050 Chariot Burnisher
5 3/16