Industries Carpet Cleaner User's Manual

HANDLE INSTALLATION

STORM POLISHER 980100 03/08/03

2-2

The machine is shipped with handle unassembled.

Follow these steps for installation:

1. Remove handle and deck assembly from carton.

2. Attach handle assembly to base using hardware kit (47331) (attached to handle in a plastic bag) items 1, 2,

and 3.

NOTE: The spacers (items 1) are required for the correct operation of the handle. The spacers are positioned

completely inside the pivot holes in the casting, and are held in place by tightening the bolts and washers (items 2

and 3) against the spacer.

3. Remove bolt, nut and washers (items 4, 5 and 6) from lower block on handle assembly. Attach links as

shown. Tighten bolt and nut securely, then back off 1/4 to 1/2 turn.

4. Check handle for movement up and down.

5. Plug motor cord into handle cord receptacle.

This must be installed by qualified personnel. Read all

instructions thoroughly. The machine is shipped with

handle unassembled.

SEE NOTE

ASSEMBLY

DECK

HANDLE

RECEPTACLE

WHEN INSTALLING THE HANDLE

ASSEMBLY, CHECK ORIENTATION OF

THE CORD ASM AND CORD HOOK.

MOTOR

PLUG

HOLE

PIVOT