manual

INSTALLATION

1. STANDARD INSTALLATION

a. Make sure all preparation steps are completed.

b. Determine your ceiling height to verify if you will require an extension..

i. Unit height from edge of glass = 3-1/4‖ (30‖ model only)

ii. Unit height from edge of glass = 4-1/4‖ (36‖ model only)

iii. Unit height from edge of glass = 6‖ (42‖ model only)

iv. Standard DC height = 16-1/2‖ (lower) + 22-7/8‖ (upper w/ luvers)

v. Minimum height (Standard duct cover only) = 24-3/4‖

vi. Minimum height (Standard duct cover w/ DK) = 24-3/4‖

vii. Maximum height (Standard duct cover only) = 38-5/8‖

viii. (OPTIONAL) HILDC height = 22-7/8‖ (lower) + 36-1/4‖ (upper)

ix. (OPTIONAL) Long DC minimum height = 40‖

x. (OPTIONAL) Long DC maximum height = 55-1/8‖

xi. (OPTIONAL) HISDC height = 36-3/16‖ (lower) + 39-1/4‖ (upper)

xii. (OPTIONAL) Special DC Minimum height = 42-3/16‖

xiii. (OPTIONAL) Special DC Maximum height = 75-1/4‖

xiv. Standard Installation = Hood + standard DC

xv. 9’ – 11’ Installation = Hood + Long DC

xvi. 11’ – 12’ Installation = Hood + Special DC

c. Determine the location you want to install the range hood. (Fig. 2a)

d. Prepare ceiling and locate wood support.

e. Mount the unit upper support frame to the ceiling.

f. Cut a 7-1/2‖ round opening at the ceiling for ducting pipe.

g. Adjust the (4) arms to desired height.(Fig. 2b)

h. Attach upper duct cover to upper support frame.

i. Use a spirit level to ensure the support frame is leveled.

j. Slide lower duct cover toward ceiling and hold.(Fig. 2c)

k. Install ducting through the ceiling.

l. Secure hood from all sides with the (8) provided screws.(Fig. 2d)

m. Installation is complete when hood is securely in place. (Fig. 2e)