WINDSTER"™ www.windsterhood.com 5101 Commerce Drive Baldwin Park, CA 91708 Tel: 626-962-8600 Fax; 626-962-8669 Toll © 2006-2011 Winters Hoods, Inc. Specifications subject to change without notice. WINTERS www.windsterhood.com OPERATION MANUAL R-18L36SS R-18L42S8S For residential and Indoor use only.
WINTERS Defective Products: All products will he inspected, tested, and carefully packed by the manufacturer before shipping to customers. Products that are damaged during transit czm only be exchanged for the same product, under the condition that the customer must get a RMA (Re tum Merchandise Authorization) from Winters. When products are received defective, you must notify us within the 3 business days of receiving the package. Replacement products are only shipped when the RMA is issued. NO EXCEPTIONS.
WINTERS Limited Warranty Winters Hoods Inc, wanna this product against doctors in material ar workmanship ss follows: 1) Labor: For a period of one (1) year from the date of purchase, if this product is determined to be defective, Winters will repair or replace the product, et its option, at no charge. After the warranty period, you must pay for all labor charges. During the “labor” warranty period there will be no charge for labor.
A. IMPORTANT SAFETY INSTRUCT! Read and Save These Instructions 1. Make sure the power is off before installing, wiring or maintenance. 2. Please keep ths range hood clean. 3. To get the best performance, the vertical clearance between the cook top and the range hood should range from 28" to 32°. (Flag} war o Fig.1 : Optimum range hood height Ducting method A.
S. DIAGRAM v Side 18" 10-114" 3/16" hl7 +d 28" ¥ Chimney duct cover 17-174" — Important Safety Instructions WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: DO NOT spray any liquid form cleanse on hood surface Including lights and control switch. To clean the range hood, spray liquid form cleaner directly onto cleaning cloth for hood cleaning. A. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. B.
Warning To reduce the risk of injury in the event of a range top grease fire, observe the following: A. SMOTHER FLAMES with a close fitting lid, cookie sheet, or metal tray, then turn off the burner. Be careful to prevent burns. If the flames do not go out Immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. B. NEVER PICK UP A FLAMING Pan You may be burned. C. DO NOT USE WATER including wet dishcloths or towels violent steam explosion will result. D. USE AN EXTINGUISHER ONLY IF: 1.
Q. PARTS LAYOUT DIAGRAM 1 | LED light 8 | Chamber 15 | Cll container 2 | Control board 8 | Motor 18 | Inner chimney duct cover 3 | LED driver 10 | Turbine Impeller | 17 | Outer chimney duct cover 4 | Transformer bracket | 11 | Oil tunnel 18 | Inner telescopic stack 5 | Capacitor 12 | Bottom casting 18 | Outer telescopic stack 6 | Processor board 13 | Oil net 7 | Hood casting 14 | Safety screen Wiring to Power Supply & SAFETY WARNING RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED.
C. TOOLS AND MATERIALS REQUIRED + One common screwdriver. + Slier (for opening electrical knockout). + Electrical wire and supplies to comply with local cords. + Electrical prows drill. D. RANGE HOOD AND WAIN PARTS BOX 1. Operation manual 2. Range hood 3. Duct ring v2. Range hood v3. Ducting <> duct ring conversion 6" duct ring standard i 0. TROUBLESHOOTING Symptom Correction Fan are not opera table. A. Check power source to see If It Is normal. B.
M. MAINTENANCE INSTRUCTION 1. Maintenance shall be important than repair. Please take care of the needed maintenance in order to secure and extend the excellent functions and using life. Note : Before repairing the range hood. Disconnect the power source. 2. After using the machine, wipes the machine by neutral detergent in order to keep it clean and maintain the appearance with brightness and sanitation. 3.
E. INSTALLATION OF TELESCOPIC STACK Important : At least 2 persons or more to install this hood Material preparation : a. Mounting temple b. Telescopic stack ©. 2 pieces cross framing lumber (2"x10%) d. 8 (432mm), 8(4x8mm) screws 8. Duct connector conversion {for 7” pipe use only) . On the ceiling, please sack the desired position, and be sure to mark the appropriate center line of range or cook top. Note : check from rang / cook top to the ceiling. (Fig.
48mm) — temporary craw screw Fig.7 Hold the outer chimney duct cover up by temporary crews then continue to Install island hood to snd of telescopic stack by fastened B Important | 2 persons for ion job. Wire box / cover Figs Remove the wire box cover and knockout from wire bax, Connect ths conduit connector In the wire box tha connect to match the corals i During smarter Taunt Sci e Sandpipers cagoule arranger Sade, Fas Use ths right size of round pipe to connect the duct by collar. } Side down ward Fig.
. Insert the power cord to the wire box, and connect the conduit connector in the wire box, and check 3 wires in different colors, black, white and green, then connect to match the colors ie, Black te Black White to White Green to Green 13. Before closing the wire box cover, must make sure there are no wires between the cover and box to avoid off short circuit. Ll. INSTALLATION OF DUCT WORK 14.