ISLAND SERIES www.windsterhood.com RA-7630SS RA-7636SS RA-7642SS RA-7648SS NOTE: PLEASE INSPECT HOOD IMMEDIATELY UPON RECEIVING. CLAIM OF DAMAGE AFTER 7 DAYS OF DELIVERY WILL BE DENIED. This unit is designed for indoor residential use only. DO NOT USE OVER A WOOD GRILL OR MOUNT IN OUTDOOR ENVIRONMENT. Please read this operation manual thoroughly before using your range hood. Store it in a safe location for when you need to reference it in the future.
TABLE OF CONTENTS 1 Table of Contents Safety Information .............................................................. 2 3 Content Checklist ..................................................................... 4 Measurements ........................................................................... 5 Preparation ................................................................................ 6 Installation ...........................................................................
2 SAFETY INFORMATION SAFETY INFORMATION TO REDUCE THE RISK OF A FIRE, ELECTRICAL SHOCK, AND/OR INJURY OBSERVE THE FOLLOWING: Unit is intended for indoor residential use only. If you should have questions, contact the manufacturer at the address or telephone number listed in the warranty. In case the unit should need to be cleaned or repaired, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally.
SAFETY INFORMATION . 3 TO REDUCE THE RISK OF FIRE, OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE. Regardless of heat level, never leave any surface materials unattended while operating an open flame. Always turn hood ON when cooking at high heat or when flambéing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambé). Depending on amount of usage, clean ventilating fans and filters frequently. Grease should not be allowed to accumulate on fan or filter.
4
MEASUREMENTS 5
6 PREPARATION PREPARATION 1. BEFORE YOU START **BE SURE YOUR UNIT WILL FIT YOUR CEILING HEIGHT** **DO NOT INSTALL IF DAMAGED** **RETURN OR EXCHANGE WILL BE DENIED IF INSTALLED** a. Be sure you have all the content of your purchase and required tools for this installation. b. Installation may take at least 2 to 3 hours from start to finish. c. Plan to use as few elbows or turns as possible for more efficient air flow. d. Collar size may need to be increased if utilizing a long duct run. e.
INSTALLATION 7 INSTALLATION 1. STANDARD INSTALLATION a. Make sure all preparation steps are completed. b. Determine your ceiling height to see if you need an extension. i. Hood unit height = 12 ii. Standard DC height = 15-3/4 (lower) + 17 (upper) iii. Minimumheight (Standard duct cover only) = iv. Maximum height (Standard duct cover only) = 3 v. (OPTIONAL) RA-76ExtDC Minimum height = 31-1/2 vi. (OPTIONAL) RA-76ExtDC Maximum height = 54-1/2 vii. Standard Installation = Hood + standard DC viii.
8 INSTALLATION 2. EXTENSION INSTALLATION (OPTIONAL) a. AFTER COMPLETING STEP A E OF STANDARD INSTALLATION, replace the standard support frame and duct cover with either the extension set or the short duct cover set. b. P 3. COLD WEATHER INSTALLATION (OPTIONAL) a. Check with your local building codes to see if a CFM reducer is an acceptable alternative to make-up air. b. Remove the RA-76CFMR (CFM Reducer) and inspect for any sign of defect or damage. (ie. Cracks, broken flips) c.
INSTALLATION DIAGRAM INSTALLATION DIAGRAM Fig. 2a Fig. 2c Fig.
10 OPERATION & FEATURES OPERATION & FEATURES 1. EASY ACCESS CONTROL SWITCH (from left to right) a. Button 1 ON / OFF b. Button 2 Low Speed c. Button 3 Medium Speed d. Button 4 e. Button 5 Light f. Button 6 High Speed Delay Shutoff 2. BAFFLE FILTERS a. (2) b. c. 3. CHARCOAL FILTERS **DO NOT WASH CHARCOAL FILTERS! IT WILL DISSOLVE!!** a. Insert the charcoal filters on each side of the motor on top of the white protective grill as shown below. (Fig. 3a) Fig. 3a b. Fig.
CLEANING & MAINTENANCE 11 CLEANING & MAINTENANCE WARNING!!! To prevent the possibility of a fire and explosion, do not use flammable liquids or solvents to clean the unit or any of its parts. Check to make sure all power sources are disconnected before servicing or taking unit apart for cleaning. Please thoroughly clean the unit weekly as stainless steel can rust under certain condition or by improper cleaning. 1. RANGE HOOD a.
12 TROUBLESHOOTING TROUBLESHOOTING WARNING!!! Check to make sure all power sources are disconnected before starting any troubleshooting. Safety gloves and glasses should be worn when working on the unit. Serious injury or death may occur if safety precautions are not followed. RA-76 Series Light issue (All not turning on) Single LED fixture defective (All not turning on) 1. Locate and replace defective LED fixture. 2. Complete Control Board replacement may be required 2.
PART LIST / REPLACEMENT 13 PART LIST / REPLACEMENT # Description # Description 1 LED light 9 Inner chimney duct cover 2 Control switch 10 Outer chimney duct cover 3 LED driver 11 Inner telescopic stack 4 Capacitor 12 Outer telescopic stack 5 Control board 6 Hood body assembly 7 Squirrel cage motor 8 Baffle filter
14 WARRANTY / CONTACT US WARRANTY / CONTACT US LIMITED WARRANTY Windster Hoods Inc. warrants its product against defects in material or workmanship as follows: Labor:For a period of one (1) year from the date of purchase, if the product is determined to be defective, Windster will attempt to repair the product, at its option, at no charge. After the warranty period, customer must pay for all labor charges. During the "labor" warranty period there will be no charge for any work done on the purchased model.
WARRANTY / CONTACT US 15 WHAT IS NOT COVERED BY MANUFACTURE WARRANTY 1. Damages resulting from any of the following: a. Improper installation or maintenance b. Any repair, modification, alteration or adjustment not authorized by the manufacturer or an authorized service dealer c. Misuse and/or accidents d. Incorrect electric current, voltage or power supply e. Improper setting of any control (Pressing multiple selections at the same time) f. 2.
