manual

ManualsBrandsWindster ManualsAppliances42 Inch Under Cabinet Ducted Hood

www.windsterhood.com

User’s Manual

RA-35U30SS

RA-35U36SS

RA-35U42SS

RA-35U48SS

Please read this operation manual thoroughly before

using your range hood. Store it in a safe location for

when you need to reference it in the future.

NOTE: PLEASE INSPECT HOOD

IMMEDIATELY UPON RECEIVING.

CLAIM OF DAMAGE AFTER 7 DAYS

OF DELIVERY WILL BE DENIED.

This unit is designed for indoor

residential use only. DO NOT USE

OVER A WOOD GRILL OR MOUNT

IN OUTDOOR ENVIRONMENT.

UNDER CABINET SERIES

WALL MOUNT SERIES



1 TABLE OF CONTENTS

Table of Contents

Safety Information .............................................................. 2 – 4

Content Checklist ..................................................................... 5

Measurements ........................................................................... 6

Preparation ......................................................................... 7 – 8

Installation ......................................................................... 9 – 10

Installation Diagram ................................................................ 11

Operation & Features ...................................................... 12 – 15

Cleaning & Maintenance ......................................................... 16

Troubleshooting ...................................................................... 17

Part List / Replacement ................................................... 18– 19

Warranty / Contact Us ..................................................... 20 – 22

Summary of content (12 pages)

PAGE 1
TABLE OF CONTENTS 1 Table of Contents www.windsterhood.com Safety Information .............................................................. 2 – 4 User’s Manual Content Checklist ..................................................................... 5 UNDER CABINET SERIES WALL MOUNT SERIES Measurements ........................................................................... 6 RA-35U30SS RA-35U36SS RA-35U42SS RA-35U48SS Preparation ..................................................................
PAGE 2
SAFETY INFORMATION SAFETY INFORMATION SAFETY INFORMATION TO REDUCE THE RISK OF A FIRE, ELECTRICAL SHOCK, TO REDUCE THE RISK OF FIRE, OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE.  AND/OR INJURY OBSERVE THE FOLLOWING:      Unit is intended for indoor residential use only. If you should have questions, contact the manufacturer at the address or telephone number listed in the warranty.
PAGE 3
SAFETY INFORMATION 4 5 CONTENT CHECKLIST CONTENT CHECKLIST PROP. 65 WARNING FOR CALIFORNIA RESIDENTS:  This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. 1. CONTENTS INCLUDED a. (1) RA-35U series (30”, 36” 42” or 48”) hood assembly b. (1) User’s manual c. (1) 8” round transition collar d. (2) Baffle filters w/ handles (30” model only) e. (2) Baffle filters w/ handles & (1) stainless steel filler (36” model only) f.
PAGE 4
MEASUREMENTS 6 7 PREPARATION PREPARATION 1. BEFORE YOU START **DO NOT INSTALL IF DAMAGED** **RETURN OR EXCHANGE WILL BE DENIED IF INSTALLED** a. Be sure you have all the content of your purchase and required tools for b. Installation may take at least 2 to 3 hours from start to finish. c. Plan to use as few elbows or turns as possible for more efficient air flow. d. Collar size may need to be increased if utilizing a long duct run. e. At least 12” of vertical duct is required before any turn.
PAGE 5
PREPARATION 8 9 INSTALLATION INSTALLATION 1. UNDER CABINET INSTALLATION a. Make sure all preparation steps are completed. b. Feed the wires coming out of the hood through the bottom of the cabinet. c. Lift the unit up flush against the wall and the bottom of the cabinet. d. Using the screws and washers provided, insert into each of the keyhole openings and tightly secure the unit against the bottom of the cabinet. NOTE: Install more screws through the back of the unit if necessary. e. e.
PAGE 6
INSTALLATION 10 11 INSTALLATION DIAGRAM 3. COLD WEATHER INSTALLATION (OPTIONAL) a. Check with your local building codes to see if a CFM reducer is an b. Remove the RA35CFMR (CFM Reducer) and inspect for any sign of INSTALLATION DIAGRAM acceptable alternative to make-up air. defect or damage. (ie. Cracks, broken flips) c. For UNDER CABINET installation: COMPLETE Step A – D of Section 1 UNDER CABINET INSTALLATION THEN GO TO STEP E BELOW. d.
PAGE 7
12 OPERATION & FEATURES 13 OPERATION & FEATURES OPERATION & FEATURES 1. EASY ACCESS CONTROL SWITCH (from left to right) a. Button 1 – ON / DELAY SHUTOFF / OFF b. Button 2 – Light control c. Button 3 – Speed control d. Blue color speed indicator 4. PUTTING IN THE OIL TRAY AND BAFFLE FILTERS a. Insert the oil tray into the unit at an angle and slide it down at the slot located next to the heat lamp sockets. (Fig. 3a) 2. HEAT LAMP LIGHTING a. (2) 250w heat lamp (NOT INCLUDED) 3.
PAGE 8
14 OPERATION & FEATURES 5. GU10 LED 5W LIGHT FIXTURES a. A set of (2) (3) GU10 5W LED light fixtures will be included. b. Additional Halogen or GU10 LED lamps may be purchased separately at c. Light sock can accommodate both halogen and LED lamps without the your local hardware store. need to change the transformer. 6. REPLACING LIGHT SET **NOTE: BE SURE THE LIGHTS ARE NOT HOT * Use maximum of GU10 5W LED light bulb * a. Unscrew outer light ring counter clock wise. b.
PAGE 9
CLEANING & MAINTENANCE 16 17 TROUBLESHOOTING CLEANING & MAINTENANCE WARNING!!! To prevent the possibility of a fire and explosion, do not use flammable liquids or solvents to clean the unit or any of its parts. TROUBLESHOOTING WARNING!!! Check to make sure all power sources are disconnected before starting any troubleshooting. Safety gloves and glasses should be worn when working on the unit.
PAGE 10
PART LIST / REPLACEMENT 18 PART LIST / REPLACEMENT 10 11 12a 12b 12c 12d 19 PART LIST / REPLACEMENT # Description # Description 1 2 Duct cover (optional) 9 Support panel Hood bracket (optional) 10 Capacitor 3 Hood body assembly 11 Squirrel cage motor x 2 4 Oil tray bar 12a (2) baffle filters (30” model) 5 Heat lamp light socket 12b (2) baffle filters / (3) fillers (36” model) 6 GU10 5W LED lights 12c (2) baffle filters / (3) fillers (42” model) 7 Control switch 12d (3) ba
PAGE 11
20 WARRANTY / CONTACT US WARRANTY / CONTACT US WARRANTY / CONTACT US 21 *Windster Hoods, Inc. reserves the right to determine the validity of your warranty claim. LIMITED WARRANTY WHAT IS NOT COVERED BY MANUFACTURER WARRANTY Windster Hoods Inc. warrants its product against defects in material or workmanship as follows: 1. Labor: For a period of (1) year from the date of purchase, if the product is determined to be defective, Windster will attempt to repair the product, at its option, at no charge.
PAGE 12
22 WARRANTY / CONTACT US CONTACT US Windster Hoods, Inc. www.windsterhood.