Vintner Series VIN—INDGTDISP beam support QLA \\ N 7NNl D il D\ N i) LNl Wine Cellar Innovations 4575 Eastern Avenue Phone: (800) 229-9813 Fax: (513) 979-5280 www.winecsllarinnovations.
Rev: 4/8/08 Vintner Series Individuals— upper Common#1 Rack Common#2 Rack 11 Notch spacer bars 3 Notch spacer bars Top Trim Stack able Beam Supports Double #1 Racks Left Rack Double #2 racks Bottom Trim Bag of nails Right Rack NN N 8 screws #8 screws Hardware Pack containing 6 2 1°Corner Brace 2 plastic anchors 21 2 5 Parts List qty. | description 7 CROAK Wil Yol UYL www.winecellarinnovations.
1. Attach (4) spacer bars to the back of the racks with nails. The top spacer bar should have a nail just on each end and the middle notch, the middle spacer bar gets nails in each notch, the 3 notch spacer bars should have a nail in each end notch. This can be done with the provided nails or with a brad mailer. This spacer bar only should receive nails A~ every notch. The back of the rack has all square cut rails, the front will be beveled. Rails are recessed where spacer bars are to be placed. 2.
Rev: 4/8/08 lower Vintner Series Individuals— w/Display ] NG B Ad /4\\9 screws #B screws 8", www.winecellarinnovations.com Hardware Pack containing 11 Notch spacer bars 7 Notch spacer bars 3 Notch spacer bars Bottom Trim Top Trim 2 1"Corner Brace 2 plastic anchors Phone: (800) 229-9813 Fax: (513) 979-5280 Common#1 Rack Common#2 Rack Right Rack Double #1 Racks Left Rack Double #2 racks Bag of nails 21 2 5, Parts List SRS qty.
1. Attach (7) spacer bars to the back of the racks with nails. The bottom spacer bar should have a nail just on each end and the middle notch, the middle 11 notch spacer bar gets a nail in each notch, the 3 and 7 notch spacer bars should have a nail in each end notch. This can be done with the provided nails or with a brad mailer. 18k This spacer bar only "‘I 3 should receive nails every notch.
use (unattached) bottom trim board of upper kit to properly align beam support beam support trim board Attach stack able beam supports to bottom of upper kit. 6. Attach bottom trim of upper kit to racks with nails provided. 5. Place upper kit on top of Nail through front beam support into top trim of lower kit. Note: you do not need to nail through back beam. support. lower kit.
Inguinal Step Securing to wall 1"#8 screw, 1"Corner Brace Note: due to ceiling height restrictions it may be necessary to attach Corner brace on under side of Spacer bar. Secure rack to wall by attaching 1'corner brace to top back spacer bar (or solid top) of unit. You will have 1 brace on the left and 1 on the right. If you are securing a kit that is stacked on top of another unit follow the instructions for installing trim kit before attaching to wall.
