Manual

2. Remove the back plate of the controller and mark

the mounting points at the desired location. (Fig. 2)

a) Mark the location of the communication

cable connection as this area will require

sufficient clearance for instance, a 1½ inch

hole in the wall for flush mounting of the back

plate. (Fig. 3)

3. Drill two one-eighth inch holes and insert anchors

(provided within the mounting surface. Anchors

may not be required if securing to a wall stud or

racking system.

4. Plug in the communication cable to the back of the

remote interface controller backing plate. (Fig.4)

a) Attach backing plate to wall using the two screws

provided with the system. (Fig.5)

5. Re-install plastic face plate on to backing plate.

6. Re-attach the communication cable to the side of

the Wine Guardian cooling unit. (Fig 6)

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6