Quick Start Owner's manual

Wine Guardian

Through-the-Wall Cooling System

“Quick Start” Installation Guide

Wine Guardian Through-the-Wall System (U.S. Pat. No. D634,760S)

Manufacturer reserves the right to make changes to this document

without prior notice at its sole discretion.

Wine Guardian is a registered trademark of Air Innovations.

For more information about your Wine Guardian

Through the Wall cooling system, visit

www.wineguardian.com/distributors

or call +1 315 452 7400.

This document is a pictorial guide on installing the Wine Guardian Through-the-Wall cooling system. It is not

intended to replace the detailed instructions found in the Installation, Operation and Maintenance manual,

which includes important safety messages all Wine Guardian installers and owners should carefully follow for

safe and optimal performance of the system

Refer to the Installation, Operation and Maintenance manual for instructions related to duct collars and duct

collar kits, optional remote interface control and remote sensors.

Rev. 02-13

PAGE 1
Wine Guardian® Through-the-Wall Cooling System “Quick Start” Installation Guide This document is a pictorial guide on installing the Wine Guardian Through-the-Wall cooling system.
PAGE 2
1. Prepare the wall A. Find wall stud locations on desired wall and mark edges of the studs. B. Locate unit height where controls can be reached. 5. Fasten sleeve to wall A. Insert wood screw into lower pre-drilled hole either side of sleeve. Tighten until snug. B. Insert screw into upper pre-drilled hole on side of sleeve, continue to middle set of holes. Tighten until snug. C. Repeat process with all screws until snug and heads are flush with the inside of the sleeve. 2. Mark desired location A.