Use and Care Manual

Figure 2
Figure 1
INSTALLATION
This SENSAR antenna may be installed inside or outside on any mast or pole.
DO NOT MOUNT OVER CHIMNEY OPENING.
STEP 1. Make sure "W" opening is on bottom side of antenna head, foot embossing
points down. Slide metal mounting bracket up into back bracket on antenna and
attach with pins and E-clips. See Figure 1
.
STEP 2. Insert "U" bolt thru mast clamp and mast bracket and start hex nuts onto
"U" bolt. See Figure 1.
STEP 3. Slide mast thru "U" bolt and tighten hex nuts with 7/16" wrench.
Model GS-1100 (Non-amplified Models ONLY)
Attaching Downlead Cable
STEP 4. Attach downlead coax cable to F-jack on back of antenna head and tighten
securely. (Figure 1). Tape downlead to mast and run coax cable to TV. Point the
front of the antenna (with Winegard logo) at broadcast towers of stations you
want to receive.
STEP 5. Attach "F" connector to downlead and connect to "F" jack on TV.
Models GS-2200 (Amplified Models ONLY)
Attaching Downlead Coax Cable
If using the power supply, follow these steps.
STEP 4. Attach "F" connector on downlead coax cable to the power inserter
marked "ANT/AMP". Point the front of the antenna (with Winegard logo) at
broadcast towers of stations you want to receive. See Figure 2.
STEP 5. Attach "F" connector on coax cable from DTV, Digital Converter
box, Distribution Amplifier, or splitter system to jack on power inserter marked
"TV/TUNER". See Figure 2.
STEP 6. Connect one end of the supplied 3' USB cable to the USB port on TV.
Connect the other end of USB cable to the USB PWR port on the power inserter.
See Figure 2.
TIP: If using a splitter to distribute signal to more than one TV, connect the USB
cable to the 110V wall adapter instead of the TV USB port.
TIPS:
If splitting the signal to multiple TVs or combining with another signal source, it is
strongly recommended that the power inserter be installed between the antenna
and the splitter/combiner input. In this case, the cable connection from the “TV”
jack of the power inserter goes to the splitter input or valid combiner input. Use
splitters rated from 54-806 MHz or wider bandwidth (commonly 5-1000 MHz)
for over-the-air television signal distribution.
Additional distribution/inline amplifiers must be installed FOLLOWING the TV
output of the power inserter, NOT on the downlead cable line connecting to the
ANT/AMP port. Check TV picture quality and antenna alignment prior to adding
additional line amplifiers.
A maximum antenna-to-power inserter length of 150 feet RG-6 or 150 feet RG-
59 is acceptable.
ANT/AMP
USB
PWR
“ANTENNA IN”
TV/TUNER
WARNING:
INSTALLATION OF ANTENNAS NEAR POWER LINES IS DANGEROUS.
FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.
Point the front of the antenna
(with Winegard logo) at broadcast
towers of stations you want to receive.
F-jack
Pins
Hex Nuts
U-Bolt
Mast Clamp
Mounting Bracket
Pin with E-clip