WINEGARD ® RoadTrip® MinimaxTM Stationary Automatic Satellite TV Antenna Model RT8000S (white dome) Model RT8035S (black dome) Made in the U.S.A. May also be packaged as: RTS-80W (white dome) or RTS-80B (black dome) PRODUCT REGISTRATION Please register your Winegard product by filling out and returning the Product Registration card provided or by completing the online registration form at http://www.winegard.com/registration Serial No. Winegard Company • 3000 Kirkwood St.
Parts Included • Tools Needed • Unpacking the Unit PARTS INCLUDED*: 1 Dome 1 base with electronics, dish, dual LNBF *Aftermarket versions also include all mounting hardware and cabling required for a single receiver installation TOOLS NEEDED FOR UNPACKING & INSTALLATION: Level Drill with 3/4” bit 1-1/4” hole saw (if mounting switch in wall) Phillips screw driver #2 3/8” Open end wrench 7/16” Open end wrench Sealant (consult RV manufacturer for proper type for your roof material) UNPACKING THE UNIT: 1.
Quick Reference Guide This model is PRESET for DIRECTV receivers. If you have a DISH Network or BELL TV receiver, you must change the numbered switches (see figures below). TO CHANGE SWITCH SETTINGS FOR DISH NETWORK. SIMPLY MOVE #4 & #7 TO DOWN FACTORY PRESET POSITION (#8 SHOULD REMAIN DOWN DIRECTV SWITCH SETTINGS ALSO).
6. Place the unit on the roof in its permanent loca- Decide the best location for the power and coax cables to enter the vehicle, and the location of the power switch and receiver. Drill a 1/2” hole in the roof, push wires inside. tion and mark around each base foot, Figure 3. FIGURE 3 2. Connect the Primary receiver to the Primary Port on the panel mount. 3.
INSTALLING THE POWER SWITCH Connecting TWO receivers 1. Choose a location to install the RoadTrip Minimax power ON/OFF switch. Remember when selecting a location, you will need to run the +12VDC power cable from the RoadTrip Minimax antenna to the switch. Be sure the switch is in the OFF position before continuing. See Figure 7 below. 1. Connect the coax cable coming from the antenna to the “SATELLITE IN” input on the primary receiver.
Basic RoadTrip Minimax Antenna Wiring TV COAX RoadTrip Minimax ANTENNA RECEIVER POWER SAT IN COAX 120V POWER 12VDC To toggle between satellites when subscribing to multi-satellite programming— television are turned on and your receiver is on the “point dish” menu. (Consult your owner’s manual to reach this menu.) The RoadTrip® Minimax antenna will toggle between the primary or alternate satellites for either DISH Network or DIRECTV. Both have programming on more than one satellite.
If a switch other than SW64 appears, or you have an X in one of the boxes below the satellites, repeat Check Switch Steps. 5. Your system is now set up to toggle between satellites. It will automatically move to the correct satellite when a channel is selected with your remote control. NOTE: Once these steps are completed, you won’t have to perform this test again, unless Check Switch was performed on another satellite dish, such as a home dish.
Troubleshooting PROBLEM SOLUTION The RoadTrip Minimax antenna does not attempt 1. Check +12 V wires at unit to verify the quick disconnect is locked to find a satellite or it never moves. into the socket. 2. Make sure the RoadTrip Minimax antenna is plugged in. The dish never stops on any of the signals that it sees. 1. Make sure that your receiver is set up correctly. For DISH NETWORK, the check switch should read either “Un known” or “SW64”.
Appendix A Satellite Coverage Maps and Receiver Compatibility A.1 DISH NETWORK PROGRAMMING The RoadTrip Minimax antenna will operate with most DISH Network receivers. Winegard does not recommend using receivers with hard drives not recommended by the manufactuer for mobile applications. Winegard recommends using a standard DISH Network receiver. The antenna will locate and toggle between satellites 129°, 119° and 110°.
Hybrid Mode is for use with DISH Network while in the Northeast where the 129° satellite is not available. The Map below shows the coverage area for the 129° satellite. DISH Network satellite 129° coverage area (Dotted area indicates coverage).* *Coverage maps are for reference only and do not guarantee coverage. DISH Network satellite 61.5° coverage area (Dotted area indicates coverage).* *Coverage maps are for reference only and do not guarantee coverage.
A.2 DIRECTV PROGRAMMING The RoadTrip Minimax antenna will operate with most DIRECTV receivers. The antenna will locate and continually track satellites 101° and 119°. Winegard does not recommend using receivers with hard drives not recommended by the manufactuer for mobile applications. Winegard recommends using a standard DIRECTV receiver. RoadTrip Minimax antenna will not operate in all areas where satellites 101° and 119° are available.
Specifications & Warranty Features and specifications • One button operation • UV protected plastic dome. • Supports up to 2 single or 1 dual receiver. DISH Network 129°, 119°, 110° or 61.5° • Compact size — 20” diameter, 15.6” height Shipping size - 25” x 22 3/4” x 16 1/2” Unit weight - 13.5 lbs. Shipping weight - 23 lbs. DIRECTV 119° or 101° • Operating temperature -13°F to +140°F BELL TV 91° or 82° • Specifications for max amperage 5.