How to Guide

ManualsBrandsWinegard ManualsElectrical7-Piece Outdoor Roof Antenna Mounting Hardware Kit

Installing the Mounting Feet

1. If the handle has been installed on the antenna, remove the

screws holding the handle to the antenna with a Phillips

screwdriver, and remove the handle.

2. Pull off the rubber foot pads from the bottom of the four

antenna feet.

3. Insert the threaded post up through the hole of each

attached foot, and with a Phillips screwdriver, tighten a

screw into each.

Installing the Antenna

1. Do not attempt to install the antenna in the rain or under

any wet conditions. Install in dry conditions only.

2. For best performance and to reduce signal acquisition

time, park the vehicle on a level surface that is free of

obstructions such as trees or large buildings. Make sure

you have a clear view of the southern sky.

3. Select a level spot on your roof for installation. Level the

base front-to-back and side-to-side. If the base is not

level, the antenna may require more time to locate the

correct satellite or may not locate the correct satellite.

4. Ensure proper distance to other rooftop equipment

is maintained. Be sure no roof-mounted equipment

is blocking the satellite “line of sight”; see clearance

requirements below.

Mounting foot (4)

with Screw (4)

Cable entry plate

Cable tie (2)

Mounting

screw (20)

Remove the four

rubber foot pads

Remove Handle

Threaded Post

Screw

Attached

Foot

Mounting Foot

18.8 in.

24.9 in.

31.1 in.

15 in.

40.3 in.

8 in.

12 in.

10 in.

Obstruction Height

Minimum Distance to be Maintained from Antenna

Signal Obstruction Chart

Roof Mount Kit RK-4000

For a complete list of compatible antennas, visit

www.winegard.com/mounts

For help, email help@winegard.com

or call 1-800-788-4417

2452390

Rev0 5-17

Summary of content (2 pages)

PAGE 1
Roof Mount Kit RK-4000 For a complete list of compatible antennas, visit www.winegard.com/mounts Cable entry plate Mounting foot (4) with Screw (4) Mounting screw (20) For help, email help@winegard.com or call 1-800-788-4417 Installing the Mounting Feet 1. If the handle has been installed on the antenna, remove the screws holding the handle to the antenna with a Phillips screwdriver, and remove the handle. 2. Pull off the rubber foot pads from the bottom of the four antenna feet.
PAGE 2
Roof Mount Kit RK-4000 Installing the Antenna (cont) 11. Before using the supplied mounting screws, check with your vehicle manufacturer for any special screw requirements. Screw down with two screws for each foot. After all base feet are secured to the roof, put sealant around the edge of feet and over screws. 6. Position the antenna with cables exiting toward the rear of the vehicle. 12. Decide the best location for coax cable(s) to enter the vehicle. Consider the location of the receiver(s).