Digital Satellite Mobile Antenna User Guide

ManualsBrandsWinegard ManualsRadioSD

RoadTrip

™

Digital Satellite Mobile Antenna for Two Receivers

RoadTrip SD - Stationary Satellite System

RoadTrip SDi - In-Motion Satellite System

INSTALLATION MANUAL

Made in the U.S.A.

Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000

319/754-0600 • FAX 319/754-0787 • www.winegard.com

WINEGARD

Summary of content (8 pages)

PAGE 1
® WINEGARD RoadTrip™ Digital Satellite Mobile Antenna for Two Receivers RoadTrip SD - Stationary Satellite System RoadTrip SDi - In-Motion Satellite System TM TM INSTALLATION MANUAL Made in the U.S.A. Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www.winegard.com Printed in U.S.A.
PAGE 2
Parts Included • Tools Needed • How to Unpack The Winegard RoadTrip is designed specifically for use with motorized recreational vehicles. Winegard recommends using a qualified installer familiar with RV structure and wiring to ensure proper installation and to prevent damage to RV or dish.
PAGE 3
Installation Diagram Control Unit LNBF GPS CABLE (RoadTrip SDi ONLY) ELEVATION MOTOR CONTROL UNIT MUST BE PARALLEL TO THE CENTER LINE OF THE VEHICLE AND FACE FRONT OR REAR OF VEHICLE.
PAGE 4
Quick Reference Guide Your Winegard RoadTrip satellite System has been designed to be the most user-friendly Mobile Satellite Antenna on the market today. Upon installation of the antenna, or after changing satellite service provider, simply set the switches inside of the dome to the settings shown in the Operation manual. These switches enable the dish to locate the proper satellite for your service provider, and, for the RoadTrip™SDi In-Motion system, to be set for the proper installation option.
PAGE 5
Installation Installing unit on roof of vehicle — Install in DRY conditions only! ! 5. Place the unit on the roof in its permanent loca- IMPORTANT! Do not install this system in the rain, or under any wet conditions. Moisture may affect electronics and void your warranty! tion and mark around each base foot, Figure 4. FIGURE 4 1. For best performance and to reduce signal acquisition time, park vehicle on a level surface; level the RV. 2. Select a level spot on your roof for installation.
PAGE 6
Installation GPS installation — (RoadTrip SDi only) INSTALLING THE POWER SWITCH 10. The GPS antenna is pre-wired and has a 1 meter cable running through one of the connectors. 1. Choose a location to install the RoadTrip power ON/OFF switch. Remember when selecting a location that you will need to run the +12VDC power cable from the RoadTrip to the switch. Be sure the switch is in the OFF position before continuing. See Figure 7 page 9. Determine location for GPS antenna.
PAGE 7
Installation • Wiring • Specifications Connecting the receiver — Your RoadTrip™ has now been successfully installed. Proceed to the Operation Manual for RoadTrip™ setup and for Operation Instructions. Connecting one receiver 1. Connect the coax cable from the gray coax cable of the RoadTrip™ to the “SATELLITE IN” on the receiver. 2. See page 5 of Operations Manual for receiver set-up. Connecting two receivers 1.
PAGE 8
Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601 • 319/754-0600 Fax 319/754-0787 • www.winegard.com Printed in U.S.A.