Full Product Manual

2
2
9
PUSH DOWN
WHEN SLIDING
SLIDE
4
3
UP ARROW
TOP
3
1
11
10
7
8
Antenna Assembly (cont)
STEP 3.
Align the two VHF Antenna Elements (#2) with the holes
on the center slot directly above the coax connector
of the Antenna Assembly (#1). Attach using two 3/4”
screws (#9) and tighten with a Phillips screwdriver.
DO NOT OVER TIGHTEN. Electronics are located
underneath and over-tightening could cause damage
to the functionality of the antenna.
STEP 4.
Slide the Reflector Elements (#4) into the slots of the Reflector
Assembly (#3). When sliding, push down the middle tabs of the
Reflector Assembly (#3) to allow the elements to pass through.
Continue sliding the element until it clicks in the middle hole.
Repeat this process for the remaining five elements.
STEP 5.
Attach the completed Reflector Assembly (#3) to the main
Antenna Assembly (#1), making sure the up arrow on the Reflector
Assembly (#3) is going in the proper direction. Align the two
holes on the Reflector Assembly (#3) with the holes on the Upper
Adapter (#10) and Lower Adapter (#11). Attach with two 5/8”
screws (#8) and tighten with a Phillips screwdriver.