LIMITED WARRANTY This warranty extends to the original purchaser only. This warranty is not transferable, between homes or owners an only applicable to residential use. Windily Industries, LLC provides a 3-year limited parts warranty for all range hoods. Under this warranty, you {the customer), is entitled to replacement parts at no cost to repair and restore functionality if any part of the product were to fail. No labor is provided.
( IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, READ THE FOLLOWING: » Use this unit only in the manner intended by the manufacturer. If you have questions, please contact the manufacturer. » Before servicing or cleaning the unit, switch the power off and turn power off at the electrical panel and lock the service panel. This will prevent the power from accidentally turning on.
( LOCATION REQUIREMENTS ] IMPORTANT: Observe all governing codes and ordinances. Have a qualified technician install the range hood. Theist Installer's responsibility to comply with installation clearances specified on the model/serial rating plate. Canopy hood's location should be away from strong draft areas, such as windows, doors, and strong heating vents, Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance.
Calculating Vent System Length To calculate the length of the system you need, add the equivalent feet (meters), for all vent pieces used in the system. (INSTALLATION DIMENSION RECOMMENDATIONS For under cabinet mount range hoods. Model: W112, UR012, WALRUS A. Counter top Height. B. Hood height from ceiling to bottom of the range hood filter surface: D-A. C. 24” minimum from cooking surface up to 36° maximum for Electric/Induction range tops.
M— Parts not supplied >» Duct tape > Duct work » Electrical wire connectors (for hard wired installation) 7 Ducting options (prior to installation) Always wear safety glasses and protective gloves when handling the range hood. There are two ducting options available with these models: 1. Ventilate out of your dwelling vertically by using the 6” round air vent {C} located on top of the range hood {you will need to remove the 8” round vent adapter and discard). 2.
Installing the Range Hood This installation is for mounting the product to the bottom of the cabinet. Please consult your professional installation specialist regarding the best type of mounting to slut your cabinets construction. Please be sure to read the entire instructions prior to installation. 1.
4, For final securing of the range hood to the bottom of the cabinet, screw in {4) of the #8 X 3/8” (J) screws to each of the easy installation brackets as shown below. % a For Frame less Cabinets: 5. Install the two easy Installation brackets (G) to each side of the cabinet as shown below using the #8 X 5/8" screws (I). NOTE: Cabinet constructions will differ, ensure the length of the screw is appropriate for the depth of the bottom of your cabinet.
3. Place filters {one at a time) completely inside range hood. Insert filter into groove towards the front of range hood the place the back part of the filter into the grease collector groove, Traditional Method for Framed and Frame less Cabinets Note: Hardware not provided for this assembly option. Consult with your professional installation specialist for what type of fasteners should be used for your cabinet construction.
Electrical 1. [Peritonitis hard-wired, make sure this is done by a qualified electrician in accordance with all national and local electrical codes. a) Before connecting the wires, switch the power off at the service panel | and lock the service panel to prevent power from being switched on, accidentally. B} Connect the Black to Live, White to Neutral, and Green to Ground by, either a solder or with electrical connectors, ¢] This unit must be properly grounded.
CARE and MAINTENANCE Cleaning IMPORTANT: Clean the hood and panel filters frequently per the following instructions. Replace the grease collector and filters before operating hood. Exterior Surfaces To avoid damage to the exterior surface, do not use steel wool or soap filled scouring pads. Always wipe dry to avoid water marks. Cleaning Method Use liquid mild-detergent soap and water, do not use hard abrasive cleaners.