Installation&Assembly

10
9. Make sure the range hood is level. Finish screwing the (2) 1-3/16 drywall anchor screw (E) from step 5. Do
not over tighten.
10. From the center line drawn in step 5, center the mounting bracket (H) at the top of the ceiling and insert (2)
#10 X 3/4 (F) tapping screws into the horizontal holes and attach to the wall. See below.
11. Assemble ventilation to outside ducting. Install (1) round flexible duct exhaust hose (I) to round vent air flap
(C) (attached to range hood on top of unit) and secure with duct tape. Note: If you are choosing the
ductless/recirculating mode do not install the duct exhaust hose (I).
12. Power the hood by connecting the three-pronged plug to a nearby electrical outlet.
13. For models with one mounting bracket (H), place the two pieces of Ducting (J) on top of the range hood,
making sure the vent in the upper section is towards the top and the upper section slides inside the lower
section in a telescoping fashion, note the grooves on the inside of the duct work to help guide and secure.
Lower the top duct into the bottom duct. See below. Go to step 14.
14. For models with two mounting brackets (H), remove the upper section from the bottom section.
*To properly secure the range hood, identify a
stud(s) and drill though the back of the range hood
at stud location and secure with a wood screw(s)
(not included)