Installation&Assembly

11
a) Remove screws from duct bracket (H). Insert mounting bracket inside of the bottom duct and align
the holes. Replace the screws entering the back of the duct. This mounting bracket is for support of
the ducts.
b) Reinsert the top duct of the range hood into the bottom duct. Please ensure that the 2 outer edges
of the top half slide between the mounting bracket (H) and inside walls of the bottom half. This is
needed to ensure stability of the top half of the duct. Lower the top duct into the bottom duct.
15. Place the two pieces of ducting (J) on top of the range hood. Insert the bottom section of the duct (J) to the
top of the range hood and insert (2) #6 X 3/8 SM Screws through the outer panel of the duct to the holes
aligned on the range hood and tighten.
Mounting bracket goes inside the duct
Outer edges