Installation&Assembly

17
CARE and MAINTENANCE
Cleaning
IMPORTANT: Clean the hood and panel filters frequently per the following instructions. Replace the panel
filters before operating hood.
Exterior Surfaces
To avoid damage to the exterior surface, do not use steel wool or soap filled scouring pads. Always wipe
dry to avoid water marks.
Cleaning Method
Use liquid mild-detergent soap and water, do not use hard abrasive cleaners.
Wipe with damp soft cloth or non-abrasive sponge, then rinse with clean water and wipe dry.
Do’s:
• Clean your range hood using a non-abrasive cloth or sponge and liquid detergent.
• Always wipe in the direction of the grain pattern.
• After cleaning rinse with water.
• Make sure range hood is dry after cleaning.
Don’ts:
• Do not use steel wool or like products as this will cause scratching and iron residue that could
lead to rusting and corrosion.
• Do not wipe against the grain pattern as this will impact the original finish.
• Do not use chlorine bleach.
Grease/Baffle Filter
• Remove the filter by pulling the spring release handle and then pulling down the filter.
• Wash filters as needed in dishwasher or hot detergent solution (low temperature, short cycle).
• If your model has a grease tray, please remove, drain and clean periodically.
• Make sure filters are completely dry before putting back into range hood.
• Reinstall the filter by making sure the spring release handles are toward the front. Insert filter into
upper track.
• Push the spring release handle.
• Push up on filter and release handle to latch into place.
Grease tray (If your model contains)
• Periodically remove the grease tray (M) and clean built up grease collection.
Replacing the LED light (Replacement Bulb Part Number: WRHLB1S2)
• Turn off the range hood and allow the LED light to cool.
• To avoid damage or decreasing the life of the new bulb, do not touch bulb with bare fingers.
Replace bulb wearing cotton gloves to handle bulb.