Installation&Assembly

8
Parts not supplied
➢ Duct tape
➢ Preinstalled ventilation system and ductwork
➢ Preinstalled outside duct cap or weatherproofing
Installing the range hood
This installation is for mounting the product to a wall. Ensure your wall has the proper support to hold
the range hood weight. These instructions are general guidelines, please consult your installation
specialist regarding the best type of mounting hardware and support system based on your wall
construction. All wall mounted range hoods, if possible, should be installed and supported by studs
behind the wall (hardware not included). In the event studs are not in alignment with the wall mount
mounting plate holes, a wooden cross support system may need to be retrofitted to your existing
studs. All homes are different and installations will vary.
1. Begin installation by removing the filters (G) and removing any tape on the air flow flappers (C).
2. Remove protective film from range hood and ducting. When handling the ducting please wear protective
gloves to avoid sharp edges.
3. If your model has an electronic touch sensor control panel, remove the protective plastic film covering the
control panel.
4. Insert the rubber bumpers (L) by attaching to the back of range hood at the two outside locations. For some
models, you will need to remove the two outside screws, place bumper over hole and reattach the screw.
See below. Some models have the bumper already attached.
5. Some models, due to packaging needs, may come with the mounting brackets attached to the back of the
range hood inverted and attached with screws (see below).