True HEPA Air Cleaner with PlasmaWave Technology TM Use and Care Guide
8 9 WINIX Air Cleaner 1 Year Limited Warranty When installed, operated and maintained according to all instructions supplied with this product, Winix, at its option, will repair or replace the product if it fails because of a defect in material or workmanship, as determined by Winix. If the unit is believed to be defective within the one year warranty period, please call 1-877-MY-WINIX (699-4649) to arrange for repair. Proof of the purchase date must be verified before any warranty work will be completed.
Motor Type Air Quality Sensor or incense.
Sleep Mode When set on Sleep Mode, display panel lights will dim and the unit will not go above low fan speed to help keep the room dark and quiet. Replacement Filter Indicator Light Indicates when to replace True HEPA Filter depending on usage.
NOTE: Follow these instructions for best results. 4. Replace the front panel by hooking the front panel on the top of the unit. Gently push the bottom of panel until it snaps into place. sealed plastic wrap NOTE: For the first 4 minutes after turning the unit on, air quality indicator will flash while the unit measures air quality.
indicator will illuminate when to replace the True HEPA Filter. - Auto: The unit is set to default to AUTO mode when it is first turned on. The sensor will automatically adjust fan speed as needed. - Sleep: When in SLEEP mode, the control panel will dim and the unit will operate quietly at the lowest fan speed. Note: To get back into AUTO mode, SPEED/MODE button must be pressed on unit until AUTO light is lit.
button on the unit. or the SPEED/MODE SLEEP MODE When set on Sleep Mode, display panel lights will dim and the unit will not go above low fan speed to help keep the room dark and quiet. air quality. If the unit is set on automatic operation, it will adjust fan speeds to compensate for changes in air quality.
Clean outside of unit as necessary by wiping with a dry, soft cloth; for stubborn stains, use a warm, damp cloth. The REPLACEMENT FILTER INDICATOR will illuminate when to replace the True HEPA Filter. Please note that the carbon filter needs to be changed every 3 months or as needed. The replacement period may vary depending on the hours of use, air quality, and location of the unit. after changing filter.
Compressed air may also be used to blow dust that may be clogging the sensor. With the power on, press the FILTER REPLACEMENT RESET button and hold for 5~10 seconds or until the light turns off. See page 10 instruction 5 for details.
11 11-12 12 14 15 16 17 18 13 11
