Washable HEPA Air Cleaner with PlasmaWave Technology TM Model 5500 Use and Care Guide
WINIX Air Cleaner 1 Year Limited Warranty When installed, operated and maintained according to all instructions supplied with this product, Winix, at its option, will repair or replace the product if it fails because of a defect in material or workmanship, as determined by Winix. If the unit is believed to be defective within the one year warranty period, please call 1-877-MY-WINIX (699-4649) to arrange for repair. Proof of the purchase date must be verified before any warranty work will be completed.
Motor Type BLDC Motor Air Quality Sensor Washable HEPA Filter or incense.
Winix air cleaners are simple and economical to maintain. For optimum performance, wash the HEPA filter every 6 months and replace after 6 washes. Change the carbon filter every 3 months. Washable HEPA Filter 5500 5500 Sleep Mode When set on Sleep Mode, display panel lights will dim and the unit will not go above low fan speed to help keep the room dark and quiet. PlasmaWave™ can be turned on and off using the remote control, however we recommend leaving it on all the time.
NOTE: Follow these instructions for best results. Washable HEPA Filter. 4. Replace the front panel by hooking the front panel on the top of the unit. Gently push the bottom of panel until it snaps into place. sealed plastic wrap NOTE: For the first 4 minutes after turning the unit on, air quality indicator will flash while the unit measures air quality.
AIR QUALITY INDICATOR indicator will illuminate when to replace the Washable HEPA Filter. - Auto: The unit is set to default to AUTO mode when it is first turned on. The sensor will automatically adjust fan speed as needed. - Sleep: When in SLEEP mode, the control panel will dim and the unit will operate quietly at the lowest fan speed. Note: To get back into AUTO mode, SPEED/MODE button must be pressed on unit until AUTO light is lit.
the SPEED/MODE button on the unit. air quality. If the unit is set on automatic operation, it will adjust fan speeds to compensate for changes in air quality. SLEEP MODE When set on Sleep Mode, display panel lights will dim and the unit will not go above low fan speed to help keep the room dark and quiet.
9
10
Washable HEPA Filter Cleaning 1. Turn off the unit and remove the front panel by grasping the bottom outside edges and pulling gently toward you. 2. Pull out the Carbon Pre-filter and the HEPA Filter by grasping the tabs located on each side of the filter. 3. Wash the HEPA filter with water only on both sides as shown in image and leave it to dry for 24 hours or replace the HEPA filter. ϑ 1/13/11 11 4. Place the HEPA and a new Carbon Pre-filter in the unit.
Unit Cleaning Clean outside of unit as necessary by wiping with a dry, soft cloth; for stubborn stains, use a warm, damp cloth. The REPLACEMENT FILTER INDICATOR will signal when to replace/clean the HEPA Filter. The clean/replacement period will vary depending on the hours of usage, air quality and location of the unit. Please note that the carbon filter needs to be changed every 3 months or as needed. There are two separate filters: Washable HEPA and Carbon Pre Filter.
Clean/Replace filters as needed. Compressed air may also be used to blow dust that may be clogging the sensor. using the remote control. The REPLACE FILTER INDICATOR remains lit after replacing the Washable HEPA filter. With the power on, press the FILTER REPLACEMENT RESET button and hold for 5~10 seconds or until the light turns off. See page 10 instruction 5 for details.
Washable HEPA Air Cleaner with PlasmaWave Technology TM 27
